CIPA Dual-View Clip-on Towing Mirror Installation - 2010 Chevrolet Silverado Video

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

Dexter part 10-41 is a grease seal for a mobile home utility hub. It has a specified inside diameter of 1.938-inches and an outside diameter of 2.523-inches. The nearest match we offer is the Redline part #10-40 which is a single-lip seal that has…

The grease cap part number that you referenced cross references to a drive in cap with a 2.44 inch outside diameter. If you have a standard cap then the Grease Cap, 2.44 inch OD Drive In, item #RG04-060, is the correct part. If you have a grease…

There are 4 wires coming out of the back of the Draw-Tite Activator IV Brake Controller part 5504. You are correct in that the black wire runs to the positive side of the vehicle battery through a circuit breaker. The white wire runs to the negative…

Not confusing at all. I took a look online and the 2001 Silverado 2500HD has a 12,000 lbs bumper pull towing capacity and a 15,200 lbs 5th wheel towing capacity. It's just two different capabilities of the truck. The extra weight of a 5th wheel…

You do not need to remove the bed of your truck to install the HappiJac part #LC182906-182971 that you referenced. I found a copy of the install instructions for this part number (see attached pictures) and there's no mention of the bed needing…

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

I was able to get a dimension sheet from my contact at Curt for the Curt Hitch part #C15800 that you referenced. See attached pic. I also attached a set of the installation instructions for this hitch.