Blue Ox Base Plate Kit Installation - 2007 Jeep Grand Cherokee Video

I have attached a basic brake controller wiring diagram for you. You will want to make sure that you ground the white wire to the negative post on the battery. The black wire will attach to the positive battery post. The red wire will tap into the…

I think you are going in the right direction. I would definitely replace the 14 gauge wire going to the trailer brake magnets with 10 gauge wire or larger. Usually larger than 10 gauge is hard to get into the trailer connector though. I would also…

I took a look at the online owner's manual for your 2010 Jeep Grand Cherokee, and under the "Recreational Towing" section your Quadra–Trac II model CAN be flat towed because it has a neutral transfer case, which is exactly what you…

When installing the bulbs of the Blue Ox Light Kit part #BX88267 in the light housing Blue Ox recommends using a caulk/sealant like the #AL73KV to secure it to the housing which also seals it up.

Although the Roadmaster InvisiBrake Supplemental Braking System #RM-8700 doesn't have a fancy transmitter/ receiver like the RoadMaster Even Brake System #RM-9430, the InvisiBrake system does have a LED monitor that illuminates when your towed…

While we haven't had the chance to install the Roadmaster InvisiBrake System on your 2012 Jeep Grand Cherokee yet we have installed it on the very similar 2008 Jeep Liberty. I attached an install video for this for you to check out that you can…

I spoke with my contact at Roadmaster regarding the InvisiBrake Supplemental Braking System #RM-8700 that you have installed. He stated that depending on your vehicle, priming the brake pedal in order to build the necessary pressure is completely…

The Roadmaster InvisiBrake you referenced, part #RM-8700 has a small compressor in the control box that provides the necessary air pressure to actuate the towed vehicles brakes when needed. Although the box is typically mounted under the seat, it can…

The orange wire, see wiring diagram attached, is not used for the Roadmaster InvisiBrake Supplemental Braking System, RM-8700. Roadmaster added that wire when developing the braking system and found that it was not needed, so it is not used for…

That's a good question, and the reason the Roadmaster InvisiBrake Supplemental Braking System #RM-8700 is not a very good option if you will be flat towing in mountainous or hilly areas is because it applies the same amount of braking force no…

In the Roadmaster Invisibrake system #RM-8700 the compressor will run only as much as needed for the air cylinder to reach and then maintain the pressure setting you have selected. That setting depends on the vehicle's brake pressure requirement…

It sure does. When the RV running lights are turned on, the InvisiBrake will deliver a trickle charge to the battery of the towed vehicle. I've linked you to the installation instructions for the Roadmaster InvisiBrake. If you go to the product…