Review of Rackem Tools - Landscaping Tools - RCMMS4-OVBS1 Video

The Rack'em Grass Catcher for Scag Lawn Mower with Velocity Deck #RCMMS4-OVBS1 comes with the faceplate you need along with all hardware needed for installation. The extension you are seeking is the Extension for Rack'em Multi-Mount…

The correct Grass Catcher for your Scag Liberty Z48 is the part #RCMMS4-OBS1.

Since you have the standard deck on your Scag Super Z model SSZ-18CV-48 the Rack'Em Grass Catcher for Scag Lawn Mower with Standard Deck #RCMMS4-OBS1 will fit.

I do have Rack'em Grass Catchers for certain Kubota mowers which you can see listed in the photo below. These mowers will use either the Rack'em Grass Catcher part #RCMMS4-OVBS1 or the part #RCMMS4-EXS1. If the model you have is not…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…