Review of MB Sturgis Propane Fittings - 24 Inch Long Propane Pigtail With Back Check - 100473-24-MBS Video

Due to the orientation of the vent on the regulator part #CAM59005 it is a vertical regulator. For a similar horizontal regulator what you would need is the part #108221 which is a similar 2 stage regulator but is instead designed for the…

If you have a T-fitting with quick disconnect port like on the MB Sturgis Sturgi-Stay T-Fitting for Type 1 Valve Quick Disconnect and Disposable Cylinder Ports part #103613-MBS you can back feed the propane from your auxiliary cylinder into your…

If I understand your needs correctly, you will need the MB Sturgis Sturgi-Stay T-Fitting for Type 1 Valve - Quick Disconnect and Disposable Cylinder Ports #103613-MBS and the Camco Low-Pressure LP Gas Regulator w/ 12' Long Hose #CAM57721.…

It sounds like you are looking for the Camco Propane Hose w/ Shut-Off Valve - Female Quick-Connect x ACME - 6' Long #CAM57629. This will connect to a 20 lb propane cylinder using a single stage regulator and has an integrated shut off valve.

The fitting you need is a type 1 like the MB Sturgis Propane Hose w/ Back Check - Type 1 x 1/4" MPT - 20" #100473-20-MBS. As far as the regulator, I recommend the Camco Vertical 2-Stage Propane Regulator - 160,000 Btu/Hr #CAM59313.…

The MB Sturgis Propane Hose w/ Back Check #100473-30-MBS that you referenced does have the back check feature you are looking for. The internal back-check prevents gas from leaking out of the regulator inlet.

Assuming that the 1 pound bottle can be removed and that the regulator on the grille can be used with a 20 pound tank then for a 12 inch supply hose you would need #CAM59053. It has a type 1 ACME nut at one end that connects to an ACME or P.O.L.…

I would recommend to remove and reinstall the complete trailer hub assembly to make sure all of the parts are installed properly. I am including a link to a video of how to remove and reinstall a trailer hub on a boat trailer. This video will show…

The Kenda K353 Bias Trailer Tire - 5.30-12 - Load Range C #AM10066 has a speed rating of 65 mph and like you mentioned a max load capacity of 1,045 lbs at 80 psi. However you should make sure that the combined maximum load rating is higher than the…

Since this type of regulator is typically mounted to a copper propane line you wouldn't need to mount it, but yes, the four holes on the back of the MB Sturgis #108220 2-stage regulator will allow you to mount the regulator. The holes aren't…

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

If you can send me a picture of the pigtail you're trying to replace or the inlet on your regulator I can confirm this, but it sounds like you need a pigtail with an NPT fitting as opposed to the Male Inverted Flare. The NPT pigtail which matches…