Pro Series Brake Controller - Time Delayed Controller - 80550 Review Video

Good news, I was able to look up your owners manual. According to the manual, it states that your power distribution box is located in the engine compartment near the brake master cylinder. You are looking for Fuse #4 (Trailer Tow Backup Lamps,…

I spoke with my contact at Curt, who tells me that you can simply disconnect the existing exhaust hanger, install the hitch, and then use the bolt shown in the diagram I have provided to reinstall the bracket. The bolt would pass through the…

From what you describe, your 2019 Honda Pilot is equipped with the factory tow package which includes the 7-way trailer connector. All you'll need to install a Tekonsha P3 #90195 is the #3070-P harness. The harness would plug into the…

The Dometic RV toilets like the part #DOM29FR that you referenced use the standard 1/2 inch thread size for the supply line like most toilets do.

The Thule TracRac TracONE Truck Bed Ladder Rack #TH27000XTB that you referenced, which is confirmed to fit your 2014 Ford F-150 Raptor, features a weight capacity of 800 pounds so it is more than capable of supporting the weight of your loaded…

The Badland winch 9k has a power draw of 300 amps at full load. You need a deep cycle 12V AGM battery that can handle that amperage. I recommend a battery with 650 Cold Cranking Amps (CCA). Badland Winches are an introductory winch with a not so…

It kind of depends on the accessory, but the largest channel nut that would be used is for the Eye Bolt Kit #RR43178. These channel nuts measure 2.36" long x 0.77" wide x 0.39" thick and then the diameter of the bolt itself…

If your 2015 Toyota Tacoma has a factory 7-way the correct install harness would be the part #3040-P. This adapter plugs into the 5-pin connector on your vehicle's built-in brake control wiring harness. The harness is located underneath the…

The 2015 Toyota Tacoma is part of the third generation of this vehicle and the location of the brake controller connection port is behind the left kick panel, near the emergency brake pedal. Please refer to the linked video at the :20-second mark…

To connect the Redarc Tow Pro Elite part #RED24FR to the factory wiring of your 2015 Toyota Tacoma would require two harnesses. You'd need the part #3040-P from Tekonsha which plugs into your truck and then you need the Tekonsha to Redarc…

There many possible ways to mount a stabilizer jack such as the #TJ01RT-HD you looked at. Mounting them in the orientation shown the diagram would tend to work a bit better to stabilize the trailer against side to side movement, while having the…

I do have a way for you to have a 7-way and 4-Pole connector on your 2020 Chevrolet Traverse, but there isn't a wiring harness for your car that comes with both plugs. You can use the T-One Vehicle Wiring Harness #118287, which is confirmed to…