ComeUp Electric Winch - Truck Winch - CU851840 Review Video

We do offer the replacement mounting bolts for the 60,000 lb Curt Pintle Hook #C48231. I checked with Curt and they are 5/8" diameter Grade 8 bolts, and the complete kit is the following: - Curt Bolt Kit #C48332 This kit is the required bolt kit…

The Curt Pintle Hook #C48231 is indeed rated for 60K GTW and 12K vertical load. I confirmed these specs with Curt. Those are high weight ratings but keep in mind that the nature of a pintle hook, which has a large amount of flat steel surface area to…

The Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #13018 uses M14 x 5.50 grade 8 bolts. There are replacement hardware kits available for the Curt #13018 by putting that part number into the field marked "Hitch Item Number"…

For a 3 inch hitch pintle hook setup Bhmllc what you'll need is the Super Titan Forged Pintle Hook Plate part #RP38186 which fits the 3 inch hitch size and has plate that a bolt on hook setup can attach to like with the Curt #C48231. We don't…

Most pintle hooks use a standard bolt pattern which is 3-3/8" horizontally center to center and 1-3/4" vertically center to center (see photo). Therefore, the Pintle Hook part #C48231 would be a direct fit and work well for you. It also…

I had the bolt holes on the Super Titan Forged Pintle Hook Plate for 3" Trailer Hitches #RP38186 measured, and they are actually 5/8". That being said, I suggest going with the Curt Pintle Hook #C48215 to attach to it. This does include 1/2…

The Tensioner for Bulldog Winch Standard Series Truck Winch - Wire Rope #BDW20234 or the ComeUp Cable Tensioner for DV-12, DV-15, and DV-18 winches #CU881087 are the only options for that size a winch. We have not tested them on a Smittybilt x20…

See the attached photos. The first photo shows the mounting bolts, which are 10” apart, center to center. The second photo is the roller, which is 8” in width. The last photo shows the roller bracket, which is 7.25” in width.

We have never tested the ComeUp cable tensioner part #CU881087 on the Superwinch LP 10,000 but I have attached the bolt hole measurements of the tensioner. It installs above the drum of the winch. You may be able to attach it to the Superwinch.

The roller on the Tensioner for Bulldog Winch #BDW34QR is 1" in diameter and 8-1/2" long.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.