Recommended Hand Winch For Pulling 300 lb Catamaran 60 Feet Across Beach

Question

Question:

I am looking for a winch to pull a 300 lb catamaran up the beach from the surf to seawall. The distance at low tide can be 60 ft or more. When I spool out the cable to retrieve the boat I want the ratchet engaged so the spool doesnt freewheel. What do you recommend? Will the Dutton Lainson 1100lb do the job?

asked by: Lew L

0

Expert Reply:

The Dutton-Lainson Hand Winch with TUFFPLATE Finish # DL15103 would work well for you. It has plenty of capacity, keeping in mind that the capacity of the winch decreases with each layer of cable that wraps around it. This winch does have the option to freewheel, but it features a lock to keep the winch from backing off. It will also accommodate up to 79 feet of 3/16 inch cable. The cable isn't included with the winch, and the longest length we carry is part # DL24104 for 50 feet. You should be able to find 3/16 inch cable sold by the foot at your local hardware store or home center.

I've linked you to an FAQ article about hand winches, as well as to a product demonstration video.

expert reply by: Mike L

0

Answer 1

The Dutton-Lainson Hand Winch part #DL15103 is indeed the correct replacement for the Dutton-Lainson Hand Winch Model DL1100 that you have now. This winch will ratchet to retrieve the load and then there is a free wheel feature that allows you to…

view full answer...

Answer 2

I went out to our warehouse to take a look at the Dutton-Lainson Hand Winch - 1,100 Pounds #DL15103 referenced in your question. I was able to take the measurements you are needing and have attached an image with these dimensions labeled that you can…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

To determine if a 2017 Toyota HIghlander has a factory towing harness, start by opening up the rear hatch. Then, lift up on the rear compartment panel and pull it out. Remove the two driver-side panels by pulling up on them. There, you may see a…

view full answer...

Answer 5

I'm happy to help you get what you need for towing. I did a little research to find your 2017 Toyota Highlander SLE AWD towing capacity to be 5,000 lbs. Based on that, you will not have an issue with a 3,850 lb travel trailer with 400 lb tongue…

view full answer...

Answer 6

For your 2017 Toyota Highlander that has a full sized spare, I recommend the Draw-Tite Class IV Max Frame Round Tube Receiver Hitch #DT65MR. This hitch is custom-fit for your vehicle and will allow your full size spare tire to remain stowed under the…

view full answer...

Answer 7

To add a hitch to your 2017 Toyota Highlander, I recommend the etrailer item #e98844. This hitch is custom fit and bolts to your Toyota with included hardware. It is a class III hitch with a 2" receiver. This hitch has a 6,000 lbs towing…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Recommended Hand Winch For Pulling 300 lb Catamaran 60 Feet Across Beach

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching