Wiring Diagrams for Hydrastar Electric Over Hydraulic Trailer Brake Actuators
Question:
Hi guys I have a trailer with an old Carlisle Hydrastar Electric Over Hydraulic system think its 1000 psi its very hard to read, it has 6 wires out of the actuator and I cant seem to find a wiring diagram It has Blue red green Black which is +12v and also goes to breakaway battery + White earth or -12v still connected in trailer plug Blue/white goes to break away switch Any help appreciated I have been trying for a few days to locate a diagram to see if it even still works previous owners disconnected it
asked by: Grant T
Expert Reply:
If it is a 1000 psi then it would be the Hydrastar for drum brakes. The newest one is # HBA-10 and it has different wire colors, see picture.
So you know that black is 12 volt power in and white is the ground. Blue/white goes to the break away switch. So that leaves red and green. One of those two has to be input to the Hydrastar from an in-cab brake controller.
The other, I am not sure of the function since the wiring for HBA-10 only shows 4 wire connections.
It might be similar to the Hydrastar XL, # HBAC10-CLR. If it is then it will have extra wires, 6 total, and that is because the trailer lights run through it as well. There is no red wire but a brown one. The functions are brown for trailer tail lights, yellow for left turn/brake lights, green for right turn and brake lights.
White is ground, black is 12 volt power, and blue goes to the break away switch.
It is possible that the trailer is using the adapter # HBA-CAM because the previous owner had a brake controller that wasn't compatible with electric over hydraulic brakes. I have included a second picture to show how that would wire up.
Products Referenced in This Question
Hydrastar Electric Over Hydraulic Actuator Adapter Module for Ford and Chevy Brake Controllers
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Adapters
- Hydrastar
more information >
Product Page this Question was Asked From
Hydrastar Electric Over Hydraulic Actuator for Drum Brakes - 1,000 psi
- Brake Actuator
- Electric-Hydraulic Brake Actuator
- 1000 psi
- Drum Brakes
- Hydrastar
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Search Results: 154
- Search Results: 6271
- Search Results: 3154~3
- Search Results: 13303
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Shop: etrailer Trailer Coupler Lock for Flat Lip 2-5/16" Ball Coupler - Aluminum - Silver
- Search Results: mcl922rb
- Shop: Identification Light Bar for Trailers over 80" Wide - Submersible - 3 Diodes - Red Lens
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Front/Center/Rear Hanger for Double-Eye Springs - 2-3/8" Tall - 9/16" Bolt Hole
- Search Results: snap
- Search Results: 45922
- Shop: Base Plate for Tow Bar
- Shop: Vehicle Tow Bar Wiring
- Q&A: Idler Hub To Replace TDE 46245 Hub and Rotor On Boat Trailer
- Video: Choosing the Right Trailer Wiring
- Video: HydraStar Electric Over Hydraulic Actuator Kit Review
- Shop: Brake Controller
- Video: CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE10403G Review
- Q&A: Which Trailer Electric Over Hydraulic Actuator is the Best
- Video: Mighty Cord Wiring - Trailer Connectors - A10-7W6 Review
- Article: Trailer Wiring Diagrams
- Q&A: Brake Assembly Option for 7200 lb Rated Axle
- Video: BoatBuckle Tie Down Straps - Trailer - IMF14207 Review
- Video: BoatBuckle Tie Down Straps - Trailer - IMF13110 Review
- Video: Titan Trailer Brakes T1086700 Review