Distance from the Ratchet to the E-Track Fastener of the Snap-Loc E-Track Tie-Down # SLLS28RER

Question

Question:

About how long is the length of the non-adjustable fixed end of the strap from the ratchet to the E Track fastener?

asked by: Dean S

1

Helpful Expert Reply:

I went out into our warehouse and measured the distance from the ratchet mechanism to the e-track fastener of the Snap-Loc E-Track Tie-Down Strap # SLLS28RER and found that it measures 7-1/2 inches.

expert reply by: Jameson C

1

click to enlarge

Answer 1

The 2015 Toyota Tacoma is part of the third generation of this vehicle and the location of the brake controller connection port is behind the left kick panel, near the emergency brake pedal. Please refer to the linked video at the :20-second mark for…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The shortest strap that we offer that will work with E-Track system is the Snap-Loc E-Track Tie-Down Strap w/ Ratchet and Soft Tie-Loop, #SLLS28RER, which measures 8' long. I have attached a link to all of the E-Track straps that we offer.

view full answer...

Answer 4

The Erickson E-Track Tie-Down Anchor #EM37JR is 5.2" Long, 5.2" wide and 0.5" tall. The two 5/16" holes are centered on each side of the of the bracket 2.75" from each other. Please see the attached image.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

We have two entry door lock options that can be keyless. I have listed them below, along with the cut-out dimensions that they fit. Unfortunately, your RV information does not tell me what size cut-out that you have, so you will want to verify that…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Distance from the Ratchet to the E-Track Fastener of the Snap-Loc E-Track Tie-Down # SLLS28RER

Product Page this Question was Asked From

Continue Researching