Difference Between Reflective Tape part # RTR15066PB and part # RTR15066B

Question

Question:

wat is the difference between RTR15066PB and RTR15066B.

asked by: Hilton

1

Helpful Expert Reply:

The difference between the conspicuity tape part RTR15066B and part # RTR15066PB is that the # RTR15066PB is perforated which makes installation easier. This version has replaced the previously mentioned.

expert reply by: Jameson C

1

Answer 1

If you check out the help article I attached below you'll see info on when conspicuity tape is needed like part #RTR15066PB for 6 inch by 6 inch or part #RE18T for 7 inch by 11 inch. The size differences basically come down to what best fits…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 4

The Trimax Puck Lock for Trailer Door Hasps #TMX96RR cannot be keyed alike. While disappointing I'm sure, there is another option to consider, which is to order a quantity of two of the Trimax Puck Locks for Trailer Door Hasps #TMX73FR. The…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 7

So the number GH-8045AL you are seeing is the Gen-Y part number for our #GY58GR. So everything is okay with that. As far as the height and the mounting holes it can vary so much from camper and vehicle that I always say it is best to just ensure you…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Since you're talking about an offset ball and don't want a slider it sounds like you have the 2024 Sierra 3500 short bed. Even with the offset you aren't going to be able to make a full 90 degree turn. I'm also not sure what your…

view full answer...

Difference Between Reflective Tape part # RTR15066PB and part # RTR15066B

Product Page this Question was Asked From

Continue Researching