Installation of the Westin Platinum Chrome Side Step Replacement Pads
Question:
Original pads installed via clips that were molded into pad. How do these replacement clips connect to replacement pad?
asked by: Greg
0
Expert Reply:
The Westin Platinum Series CPS Replacement Step Pad, item # 26-0001, has a post or clip that is molded into the under side of the pad. You place the Westin Replacement Barrel Clip for item # 26-0001, in the tube step and then the pad is pressed into place with the posts inside the barrel clips.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Replacement Step Pad for Westin Platinum Series Nerf Bars - 20" Long - Qty 1
- Accessories and Parts
- Nerf Bars - Running Boards
- Step Pad
- 4 Pegs
- 20 Inch Long
- With Clips
- Westin
more information >
Continue Researching
- Q&A: Recommended Replacement Nerf Bars for a 2002 Jeep Wrangler
- Q&A: Availability of Bully Nerd Bar Replacement Step Pads
- Q&A: Replacement Step Pad For 3 Inch Nerf Bars With 20 Inch By 3 Inch Pad
- Q&A: Replacement Step Pads For Nerf Bars 21x3 Inches With 4 Posts
- Q&A: Replacement 20 x 3 Inch Replacement Step Bar Pads
- Q&A: Peg Dimension for Replacement Step Pad for Aries 3" Wide Oval Nerf Bars Replacement Pad
- Q&A: Barrel Clips Measurement To Determine Compatibility with Nerf Bars
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)