Trailer Wiring Harness Recommendation for a 2000 Toyota Tundra

Question

Question:

i have a2000 toyota tundra. is it the right kit for this vehiclt?

asked by: Rich

0

Expert Reply:

Yes, the Curt Wiring harness part # C55367 that you referenced is confirmed to fit all model 2000 Toyota Tundras so it should work very well for you.

I attached a set of installation instructions for you to check out also.

expert reply by: Jameson C

0

Answer 1

The Curt T-Connector Vehicle Wiring Harness, part #C55367 is designed to fit the 2000 Toyota Tundra. The connector the harness attaches to is located behind the rear bumper. I have attached a photo that shows where the vehicle plug is located. In the…

view full answer...

Answer 2

The ground pin of a trailer side 7-way connector like the 7-Way Molded Trailer Wire Connector, 4' Long #H20043 you were looking at is the 5 o'clock position as shown in the included picture. For the vehicle side of the 7-way connector it…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 5

We do have actuators that will work with a trailer that has disc brakes and an 8,000 lb GTW. The Titan #T4747200 may be a great option depending on the hitch ball size you need. It works with a 2-5/16" hitch ball, bolts onto 3" wide channel…

view full answer...

Answer 6

We have the perfect replacement for your Global Direct GDC-80 brake actuator. Since you mentioned "down tongue" I believe you were referring to having an actuator with drop. If you have disc brakes, the best option is the Demco Hydraulic…

view full answer...

Answer 7

It looks like the connector you need is actually already plugged into something which I have pointed out in the picture you sent. The empty plugs on the right side do not seem to match the connector on the Curt wiring harness #C55367 for the 2000…

view full answer...

Answer 8

Your 4-pin/5-wire wiring harness is what is called a "wishbone" type which simply means that there are two separate running light wires, one brown and one pink. This allows a separate running light wire for each side of the trailer which…

view full answer...

Answer 9

The part #HM40975 is designed to fit the round 7-way connector that is found on several vehicles. To install it would require your vehicle to have this round connector. (see picture) If instead you needed a way to hardwire in a 7-way to a vehicle you…

view full answer...

Answer 10

I spoke with my contact at Curt regarding the correct wiring harness for your 2001 Toyota Tundra. He states that it is very likely that while your truck is labeled as a 2001 model, it was actually built in late 2000 with the 2000 model factory plug…

view full answer...

Answer 11

On the 4-pole trailer wiring harnesses we offer for your 2000 Toyota Tundra, Tow Ready #118367 and Curt #C55367, the connection point is under the vehicle on the driver's side. There will be a connector to mate with the plug shown in the linked…

view full answer...

Trailer Wiring Harness Recommendation for a 2000 Toyota Tundra

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching