What Covers Do Truxedo Replacement Shur-Bond Velcro Brand Fasteners # TX1115173 Fit

Question

Question:

Are these strips the replacement strips for low pro QT #581601?

asked by: Joshua

0

Expert Reply:

The Truxedo Replacement Shur-Bond Velcro Brand Fasteners # TX1115173 that you referenced will fit all Truxedo 8-foot tonneau covers. However, for your Lo Pro QT Cover you can instead use part # TX1115174 which fits 6-1/2-foot covers.

expert reply by: Adam R

0

Answer 1

The Replacement Truxedo Shur-Bond Velcro Brand Fastener, part #TX1117876 is designed to work with TruxSport tonneau covers only. From the photo you sent it looks like you have a Lo Pro tonneau cover on your truck. The correct replacement Velcro for…

view full answer...

Answer 2

The TruXedo Side Rails 1113645 were used on a few different tonneau covers with the TruXedo Lo Pro QT Soft Roll-up Tonneau Cover being the most popular. Therefore, the Replacement Side Rail End Caps With Seals for Truxedo LoPro Tonneau Covers part…

view full answer...

Answer 3

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 8

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

What Covers Do Truxedo Replacement Shur-Bond Velcro Brand Fasteners # TX1115173 Fit

Product Page this Question was Asked From

Continue Researching