Can 55 Inch Lock Side-Door Bar Lock Assembly be Used on a Right or Left Opening Door

Question

Question:

Hello, will the bar and mounting work with a door thats is hinged on the left, and opens out to the left. The picture on youre page shows a door that opens to the right.

asked by: Bob L

1

Helpful Expert Reply:

Yes, you can use the lock side-door bar lock assembly, # 3057-55, on a door hinged on the left or right. Just flip 'er over as needed!

This version features a 55 inch long pipe. If you need a shorter version use # 305736 with a 36 inch long pipe.

expert reply by: Michael H

1

Answer 1

The Polar Heavy-Duty Cam Action Door Lock for Enclosed Trailers #PLR258-002 that you referenced will work well for you to add dual cam door locks to the dutch doors and ramp of your horse trailer. This cam action door lock can work for both right…

view full answer...

Answer 2

That would depend on several different factors such how much the door sticks out away from the trailer and how much the handle sticks out away from the door. However, if you do run into clearance issues you can always install a spacer on the hinge…

view full answer...

Answer 3

The Replacement Drum for M-3 Dual Ramp Springs - Left Hand #DRUM-M-3LH is just a replacement drum for the Conventional Ramp Door Spring Kits #ERS120D81 and #ERS160D96 so it doesn't come with a cable, but the cable itself is available as…

view full answer...

Answer 4

I was able to get the height for you of the mounting brackets for the Conventional Ramp Door Spring for 8' Wide Enclosed Trailer #M394FR. Overall, the height is 6-1/4 inches, and from the top of the opening where the spring's shaft…

view full answer...

Answer 5

The cables with the Conventional Ramp Door Springs like part #M394FR are attached to the door via anchor brackets which are included with the kit. I have attached below the excerpt from the install instructions below which goes over the cable…

view full answer...

Answer 6

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…

view full answer...

Answer 9

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 10

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 11

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 12

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Can 55 Inch Lock Side-Door Bar Lock Assembly be Used on a Right or Left Opening Door

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching