Heavy-Duty Ramp Spring Availability
Question:
I am in need of some heavy duty ramp springs with 6 inch legs, do you stock?
asked by: Chief
0
Expert Reply:
The only heavy-duty ramp springs that we offer are part # RS16933RH and part # RS16933LH. These springs have 4 inch legs, measured from the coil to the end of the leg, and fit on a 1-1/2 inch shaft. These springs are rated for 2,000 lbs of torque.
expert reply by:
John H
0
Products Referenced in This Question
Ramp Spring - 2K Torque for 1-1/2" Round Shaft - LH
- Trailer Ramp Springs
- Single Ramp Spring
- Left Hand Spring
- 11 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Product Page this Question was Asked From
Ramp Spring - 2K Torque for 1-1/2" Shaft - RH
- Trailer Ramp Springs
- Single Ramp Spring
- Right Hand Spring
- 10 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Hub for Hammer Blow Hub Part HB732 on Old Trailer
- Q&A: Can Ramp Spring # RS16933RH Be Mounted in Center of Ramp
- Q&A: How Do the Heavy Duty Ramp Springs Install on a Trailer and Ramp
- Q&A: Trailer Tire and Dual Wheel Recommendation for 10K Dexter Axle
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Does The + 0.5" Offset Move The Wheels In Closer Or Further Out On The Trailer Axle Hub?
- Q&A: Choosing/Sizing the Correct Trailer Ramp Spring for a Ramp Door
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best RV Roof Vents
- Article: Trailer Wiring Diagrams
- Article: 2022 Best Stocking Stuffers
- Article: Best Tire Chains
- Article: Trailer Maintenance Schedule
- Article: 2023 Best Gifts for Haulers & Towers