Recommended Replacement Roof Vent Cover for a 2003 Coachman Clipper Pop Up

Question

Question:

Hello Im having trouble finding the right vent cover for my 2003 coachman clipper pop up trailer. Could you direct me to the right fit?

asked by: Levi

0

Expert Reply:

Sure Levi, do you happen to know what roof vent you have? That would help get you a direct replacement, otherwise we have a universal replacement like the MaxxAir UniMaxx Universal Replacement Lid for RV and Trailer Roof Vent # MA00-335002 which will fit any vent on the market.

If you're needing like a complete roof vent cover to cover the entire unit, then you can use the MaxxAir Standard Roof Vent Cover # MA00-933066, which will also work with any roof vent on the market.

expert reply by: Bryce D

0

Answer 1

It sounds like you are replacing your older 6-pole wiring harness on your Jayco popup camper to a 4-flat connector like #HM48110. When you do this, you will have the black auxiliary wire and the blue brake wire remaining. You will no longer be able…

view full answer...

Answer 2

Sounds like you are looking for the part #37995. This is a pair of 6-way connectors that Jayco uses on their pop-ups.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

When wiring a trailer connector, it is best to wire by function, as wire colors can vary. We have an excellent wiring diagram on our website, I will provide you a link so you can look at it. If you are looking at the inside of the trailer connector…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Recommended Replacement Roof Vent Cover for a 2003 Coachman Clipper Pop Up

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching