Can Slide Be Out When Replacing Motor and How to Test Slide Out Motor
Question:
This motor aligns exactly with the part number on the motor that failed in my 2016 Jayco X213. When replacing this part can the slide be out? This motor slides a king size bed slide out the back of the RV. Also, is there a way using a multimeter to test the existing motor to make sure it is the problem?
asked by: Tom
Expert Reply:
Hey Tom, thanks for reaching out!
Yes, your slide can be out when you're replacing the motor.
To test your current motor you'll just need to swap the polarity to see if it runs. If it doesn't run then you need the Replacement Motor # LC125802 (make sure that 18:1 gear ratio is correct though if your slide uses 2 motors), but if it does run then that means you have bad wiring somewhere that needs to be fixed.
Product Page this Question was Asked From
Replacement 18:1 Tuson Motor for Lippert Through-Frame Slide-outs
- RV Slide Out Parts
- Motor Parts
- Motor
- Lippert Through-Frame Slide-Out Systems
- Lippert
more information >
Continue Researching
- Shop: Replacement 18:1 Tuson Motor for Lippert Through-Frame Slide-outs
- Q&A: Replacement Slide Out Motor for 2019 Coachmen Catalina Legacy 293QBK
- Search Results: lc125802
- Video: Review of Lippert Components RV Exterior - Replacement Motor - LC125802
- Shop: Coil SumoSprings Custom Helper Springs for Coil Spring Suspension - Rear Axle
- Shop: Suspension Enhancement
- Article: How (and Where) to Connect an RV Propane Grill
- Q&A: Lippert Slide Actuator and Motor Assembly Replacement Lippert P/N 1A 041012-24-01
- Q&A: Replacement Slide Out Motor and Gearbox for Thompson 7828696
- Q&A: Correct Replacement Lippert Motor and Actuator for a 2021 Forest River Sandpiper 5th Wheel
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: Replacement Converter Recommeendation for WFCO 8735/8740 Power Center
- Q&A: Replacement Thermostat for Dometic 3316410.012
- Article: Most Popular Wheel Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Tire Sizing
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Which RV Propane Tank Size Do I Need?
Tom
4/15/2024
Is the set screw on the top of the motor included? Also, I am getting conflicting information about the set screw. Can you verify if the hole is threaded or does it require a tap to thread the whole and a separate set screw? If so what size tap, how many threads per inch and how long should the screw be?