Firestone Ride Rite Recommendation a 2010 or 2011 Nissan Frontier

Question

Question:

On firestone ride-rite air bags, there is 2 part numbers listed. #2403 and #2558. What is the difference and which one do I buy? Thankyou.

asked by: Mike J

1

Helpful Expert Reply:

For your 2011 or 2010 Nissan Frontier you would want the Firestone Ride-Rite Air Bag Kit part # F2558. This has been confirmed by Firestone as a fit for your vehicle so I can guarantee it will work for you.

expert reply by: Jameson C

1

Answer 1

You will need the Firestone Ride-Rite Air Helper Springs #F2558 for your 2016 Nissan Frontier. You will not need any spacers as the Rough Country 2.5" leveling kit only provides lift to the front suspension. The Air Lift WirelessAIR…

view full answer...

Answer 2

The lip is supposed to be there. It appears to be a way to allow the bracket to set more level than what the frame of the truck allows since it is angled and not parallel to the ground.

view full answer...

Answer 3

The purple wire on the Hopkins 4 Pole to 7 Pole Adapter, #37185, is typically used for 12V power or reverse lights. You will want to determine the function of the center pin on your trailer's connector. If the center pin is used for reverse…

view full answer...

Answer 4

In regards to the Firestone Ride-Rite Air Helper Springs part #F2558 which are a fit for a 2014 Nissan Frontier Pro 4X, you will indeed need to use a spacer if the vehicle has been lifted in the rear. If the vehicle has been lifted 2.5" then…

view full answer...

Answer 5

I have a great rear suspension enhancement solution for you. I checked in with both our air bag manufacturers (Air Lift and Firestone), and they currently do not have an air bag system designed to fit your rear axles of your 2022 Nissan Frontier. The…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Firestone Ride Rite Recommendation a 2010 or 2011 Nissan Frontier

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching