Lift Kit for 2024 H&H Cargo Trailer

Question

Question:

I bought a 2024 HandH cargo trailer. 8.5x20’ 5k tandem axles. What lift kit is available for this trailer? Thank you.

asked by: Matthew L

0

Expert Reply:

Assuming those 5k axles have a 3" diameter the best option would be the Dexter Trailer Springs Over-Under Conversion Kit # K71-385-00 you were looking at. This will lift the trailer the diameter of the axle plus the height of the leaf spring stack. The other option would be to use the Correct Track # RR23QX. This raises your trailer by 1-1/4" or 2-1/4" and aligns your axles.

expert reply by: Robin H

0

Answer 1

Hey Jaime, yes you can replace your 25-1/4 inch 3,500 lb axle leaf springs with a 5k rated axle spring like the part #e44SR. This will increase the suspension's weight capacity and might make the ride quality a little rougher but it would fit and…

view full answer...

Answer 2

Dexter Trailer Springs Over-Under Conversion Kit, part #K71-384-00, is specified by Dexter for use only with double-eye springs. It is not suitable for use with slipper springs. It is considered by our technical friends at Dexter to be unsafe to use…

view full answer...

Answer 3

First, thank you so much for providing all the axle information on your 2007 Fleetwood Redline 33. The 4-Leaf Double-Eye Spring #e47SR is our closest match to the Lippert 702096 leaf springs that came on your trailer. You will want to order 4 of…

view full answer...

Answer 4

First, thank you so much for providing all the axle information on your 2007 Fleetwood Redline 33. The 4-Leaf Double-Eye Spring #e47SR is our closest match to the Lippert 702096 leaf springs that came on your trailer. Both are 4 leaves and the…

view full answer...

Answer 5

Yes when you do an over-under kit you have to weld the seats to the axle for it to be installed properly. It is recommended to tack weld the new spring seats into place but a complete weld job is not required when installing the over-under conversion…

view full answer...

Answer 6

Hi Bruce, To lift your trailer we'll first need to check of the suspension and see if you have torsion axles or a leaf spring suspension. If you have torsion axles then I'll need to see the axle tag in order to determine what you have so I…

view full answer...

Answer 7

Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here I…

view full answer...

Answer 8

Based on the available information for your 2022 Airstream Flying Cloud 30FB it looks like you have Dexter #11 Torflex axles. Assuming that is accurate, you need the Torflex Lift Kit - Tandem Axle - 2-7/8" Lift #K71-724-02. I recommend verifying…

view full answer...

Answer 9

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Lift Kit for 2024 H&H Cargo Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching