What Type of 7-Way Does Custer Wireless LED Tow Bar Light LIW-LDTL-7B Have

Question

Question:

The page states it is 7 pin round but the picture shows 7 pin flat. Clarification? Thanks

asked by: Robert

0

Expert Reply:

The Custer Wireless LED Tow Bar Light # LIW-LDTL-7B has a 7-way flat style connector sorry for the confusion Robert!

expert reply by: Jameson C

0

Answer 1

The Roadmaster Battery Charge Line Kit part #RM-156-25 would be the kit you would need to charge the battery of your 2015 Nissan Xterra when it is being flat towed. This type of charge setup does not require a diode nor does it have potential to…

view full answer...

Answer 2

The online owner's manual only lists emergency towing and requires that all four wheels are off the ground. Based on what you've stated about the vehicle it most likely would be able to be flat towed, but you should really double check with a…

view full answer...

Answer 3

The Roadmaster battery charge line kit part #RM-156-25 would allow current/voltage to flow in either direction as it does not have a diode in it that only allows it to go one direction.

view full answer...

Answer 4

The Curt tow bar wiring kit part #C63CR that you referenced can install on a vehicle that has separate taillights like you have but there is a different wiring required when installed on a vehicle like then instead of a combined setup. You would run…

view full answer...

Answer 5

Since it will be connected to your motorhome, you do not need any type of battery charger in your 2019 Jeep Wrangler Unlimited when using the wiring kit from Curt: - Curt Wiring Kit #C63CR

view full answer...

Answer 6

The red wire that connects to the battery on your 2016 Jeep Wrangler Unlimited will need to be attached to the silver terminal labeled as "auxiliary" on the circuit breaker that comes with the Roadmaster Battery Charge Line Kit part…

view full answer...

Answer 7

Yes, you can use the Curt Universal Tail Light Wiring Kit for Towed Vehicles #C63CR to sync your motorhome lights to your 2012 Toyota RAV4. This part will make the RAV4's lights work as a combined system while it is being towed. It is legal for…

view full answer...

Answer 8

To connect the Roadmaster Battery Charge Line Kit for Towed Vehicles #RM-156-25 to your tow vehicle, you're going first want to mount the included circuit breaker with the included self tapping screws. Next, you're going to want to strip the…

view full answer...

Answer 9

For your Brake Buddy, the power should come from your vehicle battery to prevent a loss of power to your braking system. However, if you utilize the 12V power at your 7-way and use the Roadmaster Battery Charge Line Kit for Towed Vehicles #RM-156-25…

view full answer...

Answer 10

There is a possibility of back feeding but this should not really be of a concern as the odds of it happening are slim to none. If you did choose to use a diode then you would need one rated for the components it would be powering. The highest rated…

view full answer...

Answer 11

The Hopkins #48955 taillight diode kit can indeed be used to drive the running /brake lights on your Captiva like a three function lamp, without using the amber bulb for a turn signal. See the diagram I provided, and I'll also send you a copy as…

view full answer...

Answer 12

The Custer Wireless LED Tow Bar Light #LIW-LDTL does have a rechargeable battery and the only way to charge it is by plugging in the included 12V DC/cigarette style adapter charger. It will still function like normal when it's actually plugged in…

view full answer...

What Type of 7-Way Does Custer Wireless LED Tow Bar Light LIW-LDTL-7B Have

Product Page this Question was Asked From

Continue Researching