Load Resistor to Allow 2024 Lexus TX Detect Trailer with LED Taillights
Question:
I have a new 2024 Lexus TX with a flat 4 pin connector and the vehicle isnt properly detecting my trailer because it has LED lights. Is there an easy way to add the necessary resistance so that it detectes the trailer? Thanks
asked by: Paul
0
Expert Reply:
Easiest way would be to add load resistors on each of the trailer wiring circuits with the part # P230004A. Each circuit would need a resistor so you'd need to install three.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Putco LED Light Bulb Load-Resistor Kit - Aluminum
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Aluminum
- Putco
more information >
Continue Researching
- Q&A: Availability of Trailer Brake Drum for Dexter 023-447-00 15,000 Pound Brake Assembly
- Q&A: Correcting Hyperflashing After Installation LED Taillights on 2004 Dodge Ram 3500
- Q&A: Solution for Strobing LED Lights on Rebuilt Trailer with VW Caddy
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Intermittent Trailer Disconnected Message with Factory Brake Controller on Ford
- Q&A: How to Install Load Resistors
- Q&A: Do I Need Load Resistors For Each Light Replaced by a LED Light
- Q&A: Does Triple LED Command Electronics Tail Light Require Load Resistors on RV
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: Trailer Hitch Receiver Sizes
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Rooftop Cargo Carriers
- Article: Flat Towing Package for 2018 Jeep Wrangler JL and JL Unlimited