Would 65 inch Vortex Rhino Rack Crossbars work on the Roof of a 2002 Ford Econoline Van

Question

Question:

Have a 2002 Ford Econoline Van. Would be using Rhino Rack gutter mount RL150S10. The recommended crossbar is RRVA180S-2 which is 71 inch and would overhang the gutters about three inches on each side. Would like to use the 65 inch crossbar RRVA165-2. Would this crossbar still be long enough for the gutter mounts to attach?

asked by: Gary H

1

Helpful Expert Reply:

The 65 inch long crossbars part # RRVA165-2 that you referenced would be long enough for the roof of your 2002 Ford Econoline and would work well with the Rhino-Rack Roof Rack Legs # RL150S10 that you also referenced.

You would need to order a quantity of two of the # RL150S10 since they are sold in pairs.

expert reply by: Jameson C

1

Answer 1

The Rightline cargo bag, #RL100S20, should work just fine on your 2013 Toyota Venza. If you were to open the door, the clips would attach to the ridge directly above where the top of the door would be. Take a look at the picture I have linked. This…

view full answer...

Answer 2

You can install locks onto the Rhino Rack roof rack part numbers #RRVA165B-2, #RRRL150GMC-2, and #RRVA-FK1-2 that has been confirmed as a fit for you van, but you would need to buy that separately as part #RRVA-LEC4.

view full answer...

Answer 3

In order to install the Rhino-Rack Vortex Aero Crossbars part #RRVA180B-2 on your Rhino-Rack Roof Rack Legs part #RL150S10 you will also need to use the RLTP Leg Adapters for Rhino-Rack Vortex Aero Crossbars part #RRVA-FK1.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 6

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 7

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Thanks for all the details! We definitely have a way to get a cargo basket and an awning installed on your 2024 Toyota Highlander, although the aftermarket roof rack systems will use a clamping system with your door jambs instead of mounting via…

view full answer...

Answer 10

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 11

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 12

There is a trailer hitch receiver as well as a 4-way wiring harness that fit your 2022 Jeep Grand Cherokee WL; that said, we don't have any way to reference a VIN so you'll need to confirm if you do have the WL, which is the new model of…

view full answer...