Adapting a 4-Way Flat on a 2010 Toyota Tundra to a 6-Way Flat on a Yamaha Boat Trailer
Question:
Where on Gods green earth can I purchase a 4 to 6 pin harness? I have a 2010 Toyota Tundra with a 4 way flat connector and my boat trailer Yamaha, has a 6 way flat. Please help me
asked by: Richard L
Expert Reply:
A 6-Way flat trailer connector is not very common. To make sure we are talking about the same thing, a 6-Way flat would look just like a 4-Way flat, only with 2 additional pins.
Because a 6-Way flat is so uncommon I recommend replacing the connector on the trailer with a more common 6-Way such as # PK11604. Then on your 2010 Toyota Tundra you can replace the 4-Way with a matching 6-Way, # PK11609.
Or, even better, you can install a 4 to 7-Way adapter on the truck using # 37185 and replace the 6-Way flat on the trailer with a 7-Way RV style connector, # PK12706.
Since your truck already has a 4-Way, install # 37185 is the easier option. You will just need to plug the truck 4-Way into the adapter and ground the white wire to the truck frame. The other functions, black for 12 volt power, blue for electric brakes, and purple for reverse lights, do not have to be connected if you do not need them.
On the trailer side all you will have to do is cut off the connector and wire in the wires to the new connector # PK12706 by function following the diagrams in the link I have provided. Please note that the wire colors in the diagrams are typical but not standard. Make sure to wire the connector by function.
Products Referenced in This Question
Adapter 4-Pole to 7-Pole and 4-Pole
- Trailer Wiring
- Wiring Adapters
- Multi-Function Adapter
- 4 Flat
- Plug and Lead
- 4 Flat
- 7 Round - Blade
- Hopkins
more information >
Pollak 6-Pole, Round Pin, Trailer Wiring Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 6 Round
- Pollak
more information >
Pollak 6-Pole, Round Pin, Trailer Wiring Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 6 Round
- Pollak
more information >
Pollak Black Plastic, 7-Pole, RV-Style Trailer Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Product Page this Question was Asked From
Adapter 7-Pole to 6-Pole - Universal
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 7 Round - Blade
- Plug Only
- 6 Round
- Hopkins
more information >
Continue Researching
- Q&A: 7-Way Trailer Plug Adapter or Compatibility with Lance Slide-In Truck Bed Camper
- Q&A: Correct Tie-Downs for 2024 Ford F-250 With Bed Access Steps
- Q&A: How To Plug 1997 Lance Truck Camper Into 7-way Connector On 2016 Ford F-250
- Q&A: Lance Camper Wiring Harness Recommendation
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Intermittent Trailer Disconnected Message with Factory Brake Controller on Ford
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Article: Pintle-Hitches
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Mount a Truck Bed Camper
- Q&A: Is There an Adapter for Lance Truck Bed Camper to Standard 7-Way Trailer Connector
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)