Can The Foot Plate On The Round, Pipe Mount Swivel Jack # TJP-5002S-B Be Changed To a Wheel?

Question

Question:

Can you swap out the foot plate for a wheel on this jack?

asked by: Jennifer P

0

Expert Reply:

The foot plate on the Round, Pipe Mount Swivel Jack # TJP-5002S-B is welded to the inner tube and cannot be replaced with a wheel unless you were to cut it off and weld on a wheel. We do have the Bulldog Round, Pipe-Mount Swivel Jack # BD1541150301 which will accept both a Wheel # BD500245 and Foot Plate # BD018098 if you want to be able to use either.

expert reply by: Bud M

0

Answer 1

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 2

Hey there Gary, thanks for the photo and yes the etrailer Bolt-On Swivel Mounting Plate for 3,500-lb Trailer Jacks with a 5/8" Swivel Pin #e52JR will indeed work with your Round, Pipe Mount Swivel Jack #TJP-5001S-B.

view full answer...

Answer 3

Both of the ARK stabilizer jacks #ARK94FR and #ARK87FR can rotate 90 degrees forward and back so in a way it is 180 degrees like you asked about. The difference is the #ARK94FR has a square tube and #ARK87FR has a round tube. These are both going be…

view full answer...

Answer 4

There is no weight rating for the Mounting Bracket, part #TV-0002. It is designed to replace the bracket for the Trailer Valet Trailer Jack, part #STC-V211. The Trailer valet has a weight capacity of 500 lbs. You may be able to install a different…

view full answer...

Answer 5

There is a couple things you can try to get your Husky Brute 4500 Working again. If the light are coming on and the switch is just clicking you would need to check the star washers on your ground. Remove the ground wire from the frame and scrape the…

view full answer...

Answer 6

It sounds like you may have a ground problem on your Husky. The jack is grounded through the mounting hardware so you want to make sure the mounting hardware is making good contact with clean, corrosion-free surface on the trailer. The jack has one…

view full answer...

Answer 7

The inner diameter of the replacement mounting bracket for Trailer Valet part #TV-0002 is 2-1/2 inch. The pin diameter is 5/8 inch.

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Can The Foot Plate On The Round, Pipe Mount Swivel Jack # TJP-5002S-B Be Changed To a Wheel?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching