Auxiliary Fuel Tank For 2022 Chevy Silverado 2500HD

Question

Question:

Do you have any auxiliary fuel tanks for a 2022 Chevy high country 2500 HD?

asked by: Wesley E

0

Expert Reply:

I checked with DeeZee, and there is an auxiliary diesel fuel tank for your 2022 Chevy Silverado 2500HD, with the correct part number being the following:

- DeeZee Auxiliary Tank - Rectangle - Aluminum - Brite-Tread - 106 Gallon # DZ91753X

expert reply by: Kyle S

0

Answer 1

The B&W Rubber Cover for Stowed Turnoverball #BWGNXA1710 will not fit on the bottom of the Turnoverball unit. You don't want moisture to be held in, so putting a plug on the underside wouldn't be recommended even if it did fit. You want…

view full answer...

Answer 2

I took a look at what we have, and the closest I was able to get to what you need is the DeeZee Truck Bed Auxiliary Tank #DZ91752X. This fuel tank measures 19" tall, 9" wide, 59 1/2" long, and has a recommended max fuel capacity of 39…

view full answer...

Answer 3

Yes, the best option we can offer you to add fuel capacity is with the DeeZee Truck Bed Auxiliary Tank part #DZ91752X which should fit in the space you have between the cab and 5th wheel hitch no problem as it is only 9" deep. I don't have…

view full answer...

Answer 4

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 12

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Auxiliary Fuel Tank For 2022 Chevy Silverado 2500HD

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching