How Far Into Mounting Surface Does Rotary Dimmer Switch # 37215235 Install

Question

Question:

What is the depth of this switch from the mounting face to the back of the unit? I plan to install in a thin wall space and want to ensure there is clearance.

asked by: David

0

Expert Reply:

The depth of the Rotary Dimmer Switch # 37215235 that installs inside where it would mount is right at 1 inch.

expert reply by: Jameson C

0

Answer 1

The Rotary Dimmer Switch #37215235 is the only one in that style we have, but we also carry some other options which you can see linked below. The third wire on your current switch will be for the ground, and from my understanding JR Products is…

view full answer...

Answer 2

If the LED lights of your RV are dimmable yes, the Rotary Dimmer Switch #37215235 will work to dim them.

view full answer...

Answer 3

Most RV Ladders are fairly universal, so you most likely will be able to use your mounting brackets. We do have a black ladder with hinges that is a universal fit. I recommend the Stromberg Carlson RV Exterior Ladder w/ Hinges - Aluminum -…

view full answer...

Answer 4

The Rotary Dimmer Switch #37215235 is 3-9/16" tall, and 2-3/16" wide. The cutout section is 2-9/16" tall and 1-3/4" wide. The red wire is for connecting to your 12 volt positive power source while the white wire leads to the…

view full answer...

Answer 5

I attached a diagram for the switch part #37205-12315 that shows what the functions of each wire are based on color.

view full answer...

Answer 6

The easiest way to figure this out is going to be by pulling off your current switch. The RV LED Light Side-Slide Dimmer Switch #37205-12315 has a 3 wire install, the back of the switch shows which wire gets wired to where. The 3-way SW-IP you are…

view full answer...

Answer 7

I know exactly what you are looking for. We have two switches, one in white one in black, that will do just what you are asking. These switches also have a dimmer feature which you don't have to use. They are the, RV LED Light Side-Slide Dimmer…

view full answer...

Answer 8

The depth of the Rotary Dimmer Switch #37215235 that installs inside where it would mount is right at 1 inch.

view full answer...

Answer 9

I contacted Trimark in regards to a replacement part for the Trimark 030-0900. 030-0900 is actually a series number not a specific part number. To find the part number you will need to take the interior handle completely off the unit. On the back…

view full answer...

How Far Into Mounting Surface Does Rotary Dimmer Switch # 37215235 Install

Product Page this Question was Asked From

Continue Researching