Dimensions of Replacement Strike Plate for Bauer Products RV Door Locks

Question

Question:

looks like i need a replacement door strike for a crossroads zinger. I think it measures 31/2 inch by 1. I cant find if this is the correct size. thank you

asked by: Tom

1

Helpful Expert Reply:

The Replacement Strike Plate for Bauer Products RV Door Locks # BA29VR measures 3-7/8" long x 1-1/8" wide so it can be used to replace your current striker, but you'll have to accommodate for the slightly longer length. Our other options are either longer than this or they are shorter than what you're needing so this is your best bet for a replacement.

expert reply by: Jon G

1

Dimensions of Replacement Strike Plate for Bauer Products RV Door Locks
(click to enlarge)

Answer 1

I went out to our warehouse for you and measured the Replacement Strike Plate for Bauer Products RV Door Locks part #BA29VR as this was not information the manufacturer offered. The opening is 2-1/16" tall x 11/16" wide. I have attached a…

view full answer...

Answer 2

Measurements for the Replacement Strike Plate, #BA29VR, are 3-7/8" length and 1-1/8" wide. Please see the attached product review video with measurements.

view full answer...

Answer 3

Thank you for the photo, and there isn't a way to tell specifically, but that's okay because it isn't necessary. What you want is for your dimensions to match up, and so long as they do, you can use a strike plate from a different…

view full answer...

Answer 4

Hey Tony, thanks for writing in, and that's a really smart question. The answer is yes, the fresh water tank should be full when adjusting the 16,000 lb Equal-i-zer Weight Distribution System #EQ90-00-1600. What you want to do is have the trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

If you have a 2017 Toyota Tacoma with the tow package/factory 7-way yes it is pre-wired for a brake controller. For a brake controller I recommend the Prodigy P3 Brake Controller part #90195. This is our best selling brake controller because of how…

view full answer...

Answer 7

On Dexter axles manufactured after April 2001 you will be able to find the serial number stamped on the rear portion of the axle tube approximately 18" from the passenger side hub. Depending on the condition of the axle you may need some chalk…

view full answer...

Answer 8

The best suspension upgrade you can make for your 2022 Ford F-250 that is towing a trailer will be with the Roadactive suspension kit part #RAS3611-SLHD as this will do a great job getting rid of the sag and does the best job at preventing sway and…

view full answer...

Answer 9

The capacity of the suspension enhancement kits we offer for vehicles like your 2017 Ford F-350 is basically how much additional support they can provide to help out the factory suspension of the truck. So the #RAS3611-SLHD can provide up to 3,000…

view full answer...

Answer 10

FX4 model Ford trucks have different suspension than the standard trucks. Typically it's a slightly taller lift and different shocks which is why the air bag kit fits exclude them. So for a somewhat similar suspension enhancement setup for your…

view full answer...

Dimensions of Replacement Strike Plate for Bauer Products RV Door Locks

Product Page this Question was Asked From

Continue Researching