What Diameter Pin Does Replacement Retaining Washer for Solera Pitch Arm Fit

Question

Question:

What size clevis pin or pivot pin does the retainer washer fit?

asked by: Jerry N

0

Expert Reply:

The diameter pin the part # LC431583 is designed to fit is 3/8 inch.

expert reply by: Jameson C

0

Answer 1

I attached a picture I got from Lippert that has their install instructions and diagnosis page for the #LC375994 that you referenced.

view full answer...

Answer 2

For the Replacement Retaining Washers for Solera Pitch Arm Assembly - Qty 1 Item #LC431583 you can just use a socket and press them on by hand. Lippert has an install video, which I'll be sending to you, that you can see them easily doing it by…

view full answer...

Answer 3

In order to find the correct replacement arms for your 2016 Shasta Oasis you're going to need to measure the overall length of current pitch arms. If that length is accurate, then you are going to need the, Replacement Pitch Arm for Solera Flat…

view full answer...

Answer 4

We have replacement 69 inch Solera pitch arms with the part #LC375994 which is the most common size, but if you instead need a 78 inch arm you would need #LC74VR which is for the XL Flat Solera RV awnings.

view full answer...

Answer 5

Though we don't carry that exact part, we do have a strut with the same dimensions that is likely to work. Based on my research the gas strut 654150 is 26.46" when extended, has two metal ends and is 120 lbs of force. The strut we carry…

view full answer...

Answer 6

The Solera Gas Strut 26", 124 lbs for Short and Flat Awning Arms #LC280343 does not come with push nuts, you will need to locally source these. You can do this at any hardware store.

view full answer...

Answer 7

I have a solution for you but we do not carry an exact replacement for the 654150 0550N 091/16 strut . The strut we carry that is almost the same is the Solera Gas Strut for Short and Flat Awning Arms item #LC280343 that you were looking at. The…

view full answer...

Answer 8

Hi Charles, I recommend the High Pointe RV Convection Microwave - Black #HP99ZR or Stainless Steel #HP49ZR. These convection microwaves are 20-1/2" wide x 14-3/4" tall x 18-11/16" deep so you should be able to just squeeze it in. The…

view full answer...

Answer 9

When you go to install the Replacement Pitch Arm part #LC375994 you'd need to go with three of the retaining washers #LC431583.

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

To determine if your motorhome has the Tiffin air brake setup or Freightliner BrakeSync you'll need to look at the rear and see if there's an quick disconnect fitting for your air line. The standard Tiffin air coupler fitting would look like…

view full answer...

Answer 12

Hello John. The #C96JR tail light kit for the 2023 Jeep Gladiator will indeed work with a Brake Buddy brake System Such as part #HM39524. So, if you plan to use a portable brake system, that is definitely what I recommend, and you do not need to get…

view full answer...

What Diameter Pin Does Replacement Retaining Washer for Solera Pitch Arm Fit

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching