Comparing Bright Way 220 ah 6-Volt Battery and Go Power 224 ah 6 Volt AGM Battery

Question

Question:

I want to replace 2 Interstate GC@-ECL-UTL 6 volt flooded batteries for my RV trailer with 2 6 volt AGM batteries. I see that you carry 2 models: Bright Way BRW74FR and GoPower AGM RV battery. What are the differences between these 2 batteries? Do you recommend one or the other?

asked by: Jay F

0

Expert Reply:

I would go with the Go Power 224 amp hour 6 volt battery part # 34277606 over the Bright Way part # BRW74FR because of the warranty being 2 years as opposed to 1 year. Aside from that there really isn't much of a difference but an additional year on the warranty for such an expensive battery would be a no-brainer for me.

expert reply by: Jameson C

0

Answer 1

We don't do a core charge for our batteries, like the Bright Way Deep Cycle RV Battery #BRW37FR you were looking at - at least at this point in time (May 2023).

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You'll want to check the level of charge for the Bright Way Deep Cycle RV Battery #BRW37FR since we don't have them on a charger, but it should come with a good amount of charge. Since this is a sealed AGM battery you can install it in any…

view full answer...

Answer 6

The clicking sound you are getting of your coach step seemingly wanting to over extend or over retract is not a motor issue but rather a control module issue. This is basically the brains of the operation and if another item wasn't working…

view full answer...

Answer 7

If there is something causing a short it is possible that the motor could be running too long after extending or retracting and that could cause the problems. When replacing the parts make sure gears and other moving parts are properly lubricated as…

view full answer...

Answer 8

The replacement control module that you need for your 202-3207 control module on your Coach Steps is the Lippert part #LC301702 on our site. I reached out to my contact at Lippert who said this control module is the correct replacement for all of the…

view full answer...

Answer 9

You are going to need 4 of the Fulton Grease Caps #F001609. These have the 3.125" outer flange diameter.

view full answer...

Answer 10

The depth dimension of the faucet part #PF213246 that would be in a shower box like where it would be mounted is 3-1/4 inch from the back to the end of the quick disconnect or 2-5/8 inches to the top of the handles. I attached a picture of the black…

view full answer...

Answer 11

If you went with the Bright Way Deep Cycle Battery part #BRW74FR you'd have a 6 volt battery that is rated for 220 ah each. This appears to be double what you have now so it would be a solid upgrade.

view full answer...

Answer 12

In regards to the Replacement Consumer Lockout Key for Dexter Axle Brake Actuators part #DX94FR, this is only to be used when needing to reverse with the trailer as it will stop fluid from progressing through the cylinder applying the brakes on the…

view full answer...

Comparing Bright Way 220 ah 6-Volt Battery and Go Power 224 ah 6 Volt AGM Battery

Product Page this Question was Asked From

Continue Researching