Troubleshooting A TireMinder Tire Pressure Gauge # TMG-AAA-Multi That's Only Reading 5 PSI

Question

Question:

How do you get it to read tire pressure. Mine just say 5.0 psi when I put it on a tire valve.

asked by: Dave

0

Expert Reply:

It sounds like the TireMinder Tire Pressure Gauge # TMG-AAA-Multi is either not properly reading and needs to be reset, you aren't pressing it straight onto the valve for it to get an accurate reading, or the value is set at bar instead of psi. To reset it you can remove the batteries for a few minutes and then replace them. It'd also b worth checking the charge level of the batteries or just replace them with ones that you know are good. The button next to the display screen can be pressed to switch it back to psi, and then you'll want to make sure that you're pressing it on straight with enough force for it to press in the valve and release air into the gauge.

expert reply by: Kevin C

0

Answer 1

We always recommend running trailer tires at the rated cold PSI number found on the sidewall. Vehicle tires are a little different though because they are designed more around comfort than utility like trailer tires. You'll want to check the PSI…

view full answer...

Answer 2

The correct replacement control module for your Kwikee Steps with Control Module 909513 is the Lippert Components Kwikee Control Unit part #LC379606.

view full answer...

Answer 3

For tires that are on a trailer you always want to make sure that they are filled to their max psi (can be found on sidewall) so that you can get the performance and max weight capacity out of them. For tires on a passenger vehicle, like your burger…

view full answer...

Answer 4

The distance between the lock pin and housing on the Bulldog Lifelong Trailer Coupler Lock #BD580403 is 1-5/8".

view full answer...

Answer 5

The Replacement Converter #PD4655V is the correct converter for your Parallax 7355 power center. I do not see that WFCO shows their 8955PEC being acceptable to use with your Parallax 7355.

view full answer...

Answer 6

The Kenda 4.80-12 Bias Trailer Tire with 12" Galvanized Wheel - 5 on 4-1/2 - Load Range B #AM30590 matches all of your criteria and is my recommendation for you. For your spare carrier, I recommend the Extra Offset Trailer Spare Tire Carrier by…

view full answer...

Answer 7

Are you only installing the #LC82FR (500731)? To replace your 500210 you will need the full kit #LC359259. There are also wiring changes you will have to make at the pump assembly before it will work. After speaking with Lippert it sounds like this…

view full answer...

Answer 8

I'm not quite sure why your dealer would say to put 80 psi in the Westlake ST205/75R15 Radial Trailer Tire #LHWL300 because they say to inflate it to 65 psi which gives you 2,150 lbs for the load rating. With 4 tires this puts you over the 8K max…

view full answer...

Troubleshooting A TireMinder Tire Pressure Gauge # TMG-AAA-Multi That's Only Reading 5 PSI

Product Page this Question was Asked From

Continue Researching