Replacement Wiring Harness for Dutton Lainson SA9000 Winch

Question

Question:

Hello. I have a 12 volt strongarm Dutton-Lainson Model SA9000 i need the 12volt wire to make it work. Would item DL24151 work or do you have another wire that would work? Thank you in advance

asked by: Frank

1

Helpful Expert Reply:

The correct replacement harness for the Dutton Lainson SA9000 # DL24870 is the part # DL24151 .

expert reply by: Jameson C

1

Answer 1

Having the factory towing package on your 2022 Jeep Wrangler Unlimited will actually make life a lot easier. You will need a couple parts to get the Redarc Tow-Pro Elite up and running, but it's easier than you think. The Redarc Tow-Pro Elite is…

view full answer...

Answer 2

As long as your TW4000 Strongarm winch was made after 2014 the #DL24152 is the correct harness you'd need. We only have it in one length of 25 feet.

view full answer...

Answer 3

There is no drilling required to install the Curt Front Hitch part #C31054 on your 2011 Toyota 4Runner. This will reduce ground clearance somewhat. But it really depends on where you will be driving if it would be an issue or not. When we installed…

view full answer...

Answer 4

There is a front mount hitch for your 2015 Toyota 4Runner Limited that will not require drilling, the Curt #C31054. This hitch is a bolt-on installation and as you can see from the cutout of the installation manual I added there is no drilling…

view full answer...

Answer 5

Winches draw quite a bit of amperage so for a kit that will be rated for that type of amerage draw we have the heavy gauge kit part #BDW20043 for up to a 4k winch, or if you have a higher rated winch we have the #BDW20207 for up to 16.5k. These kits…

view full answer...

Answer 6

You could use a step drill bit in the size of 7/8 inch to 1-1/8 inch which appears to be the size our installer used when installing the etrailer hitch part #e98912 in the install video link I attached.

view full answer...

Answer 7

There are a few ways you can wire the winch. The first is to wire it with some quick-disconnects like part #DW05312 to your vehicle battery. Your battery should have at least 440 cranking amps to be able to handle the winch power. Another way is to…

view full answer...

Replacement Wiring Harness for Dutton Lainson SA9000 Winch

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching