Will Thule TracRac CapRac Fit on Tracks of Leer Canopy

Question

Question:

willl this fit on my 07 Chevy Silverado 1500 crew cab short bed with a leer canopy that has tracks on it already? Not sure what brand of tracks they are

asked by: Jason

0

Expert Reply:

Yes, the Thule TracRac CapRac part # TH29200XT would fit the tracks on your Leer canopy. That's basically what this rack was designed to for.

expert reply by: Jameson C

0

Answer 1

The Thule WingBar Evo Crossbars - Aluminum - Black - 47" Long #TH711220 weigh roughly 6 lbs, and the Thule Evo Fixpoint Feet #TH49SC weigh roughly 4 lbs. You are correct that to determine the cargo capacity of your roof rack system you…

view full answer...

Answer 2

A great roof rack we have for the Leer cap on your 2018 Dodge Ram 1500 is the Thule TracRac CapRac Ladder Rack #TH29200XT. This is easy to install and has a higher weight capacity that basically matches any roof capacity of the camper shell its…

view full answer...

Answer 3

You're in a tough spot as Thule has basically phased out your entire roof rack setup from the feet, to the bars, and the fit kit. I wish I had something I could offer that was simple and easy but based on your situation I would go with option 4…

view full answer...

Answer 4

Yes, all other components for the TracRac CapRac Ladder Rack, #TH29200XT, can be removed while leaving the swivel brackets in place. I have included a snapshot of the installation guide to show how the rack corner attaches to the swivel bracket. All…

view full answer...

Answer 5

We have just what you need! The Thule TracRac CapRac part #TH29200XT is confirmed as a fit for a camper shell on a 2018 Ford F-150 and would work great. It also fits all bed lengths too based on how it installs. This rack has heavy-duty aero shaped…

view full answer...

Answer 6

The 853-5113 part number that you referenced is the FootBase for the TK2 Tracker system. If you just need the FootBase then that would be part #753-2149. I confirmed this with my contact at Thule. If you are needing to replace the Tracker foot (part…

view full answer...

Answer 7

The correct bearing kit for your Lippert 3,500 lb axle is the Bearing Kit #BK2-100. This kit uses inner bearing #L68149, outer bearing #L44649, their accompanying races, along with grease seal #58846. I've added a link to a video review of this…

view full answer...

Answer 8

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Tracks can absolutely be installed on the roof of your A.R.E. Truck Cap to provide a mounting system for a roof rack. For this I recommend the Yakima Tracks, which come in 42 inch #Y01126, 54 inch #Y01127, and 60 inch #Y01135 lengths. These tracks…

view full answer...

Answer 11

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 12

The Rhino-Rack Roof Rack for Factory Tracks #Y02-490B-NT is going to be your best bet for the tracks on the ARE topper for your 2012 Toyota Tacoma. The weight capacity is 220 lbs like you mentioned, but that's going to be the highest you'll…

view full answer...

Will Thule TracRac CapRac Fit on Tracks of Leer Canopy

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching