SnapPad Jack Pads for 6" Diameter Feet on a Bigfoot Leveling System

Question

Question:

Snap Pad: I have a 2023 Tiffin Wayfarer with a BigFoot hydraulic leveling system 4 feet. Landing feel are 6 diameter. Which snap pad product will work?

asked by: Ivan R

0

Expert Reply:

Since you have four, 6" diameter feet on your Bigfoot leveling system, you will want the SnapPad Mini Jack Pads for Class C Motorhomes and Travel Trailers w/ 6" Round Jack Feet # SN59FR.

expert reply by: Scott S

0

Answer 1

In order to minimize sway on your 2020 Wayfarer Class C, I recommend starting with the Roadmaster #RM-1209-131 since sway begins at the rear of the coach. Adding a rear sway bar is, in most cases, the quickest and most common way to combat sway that…

view full answer...

Answer 2

I have a solution for you, however, I would not recommend mounting a tow bar directly to a bumper on a Jeep, whether it is OEM or an aftermarket bumper. Jeep does not recommend towing the Wrangler with the OEM bumper because it was not designed to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 10

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

Whether or not you can flat tow with a Jeep bumper is really up to the manufacturers testing; some of the big names like MetalCloak or Poison Spyder have bumpers with D-ring attachments that can be used for flat towing connections. This is great…

view full answer...