How Should The DC Side Of The PD4135K Power Center Be Wired
Question:
Yes on the unit it has a black lead that comes off the board the diagram shows it running thru the back of the unit dont under stand where it runs to it doesnt explain anything as to where it goes
asked by: Wade C
Expert Reply:
The wires coming out of the back of the Progressive Dynamics 4100 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel # PD4135K are for the DC distribution panel. These allow for an easier connection point for your DC electronics/appliances.
You'll connect the battery POS (+) labeled 001, to the Red BATTERY POS (+) wire and battery NEG (-) to the White BATTERY NEG (-) wire.
Your DC items go to the individual numbered wires , corresponding to fuses + side.
Your return side for DC items would go to a ground bar (not supplied) outside of the PD4045, which in turn is connected to the DC side of the system and battery. Or use the chassis as your ground for the DC appliance.
The red wire labeled 002 is for a 30 amp circuit. The remaining black wires are for 20 amp circuits.
Product Page this Question was Asked From
Progressive Dynamics 4100 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel - 35 Amp
- RV Converters
- Smart Charge
- Standard Charge
- 10-1/4L x 7T Inch
- 12V
- 35 Amps
- Lead Acid
- Lithium
- Progressive Dynamics
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Progressive Dynamics 4100 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel - 35 Amp
- Q&A: Where to Put the Negative Wires When Installing the Progressive Dynamics 4100 Series RV Converter
- Q&A: Wiring in DC Side of Progressive Dynamics PD4135k Power Center
- Video: Review of Progressive Dynamics RV Converters - Power Control Center AC/DC Panel Charger - PD4135K
- Video: Progressive Dynamics RV Power Control Center Installation - 2020 Taxa Mantis Travel Trailer
- Q&A: Can The Converter In A Progressive Dynamics # PD4135K Power Center Be Disabled
- Q&A: Troubleshooting Progressive Dynamics 4100 Series AC/DC Distribution Panel DC 40A Fuse Blowing
- Q&A: Where Does The Converter Hot Wire Get Wired To In A Progressive Dynamics PD4135K Power Center
- Q&A: Does Progressive Dynamics RV Power Control Center AC/DC Panel Converter 35 Amp Need Chassis Ground
- Q&A: Troubleshooting No Power On The DC Side Of The Progressive Dynamics PD4135K Power Center
- Shop: Replacement Converter Section for Progressive Dynamics Inteli-Power 4000 Series 45 Amp Power Center
- Shop: Mighty Cord Replacement RV Power Inlet - Twist Lock - 30 Amp - White
- Shop: Progressive Dynamics Replacement Section for AC/DC Power Distribution Panel - 45 Amp
- Shop: Progressive Dynamics Replacement Section for AC/DC Power Distribution Panel - 55 Amp
- Shop: Trailer Hitch
- Search Results: progressive dynamics
- Article: Trailer Wiring Diagrams
- Search Results: awning
- Shop: Progressive Dynamics 4000 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel - 60 Amp
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Review of Progressive Dynamics Replacement Section AC/DC Power Distribution Panel - PD4655V
- Search Results: converter
- Shop: Suspension Enhancement
- Shop: Progressive Dynamics 4000 Series Mini RV Converter w/ Charge Wizard and AC/DC Distribution Panel
- Article: Trailer Tire Sizing
- Video: Review of Progressive Dynamics RV Converters - Power Converter W Charge System - PD4045KA
- Shop: Brake Controller
- Search Results: rv converters
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
on RV Converters
