Length Of The Replacement Wiring Harness for Lippert Slide-Out Controller # LC135696

Question

Question:

What is the length of this wiring harness: Replacement Wiring Harness for Lippert Slide-Out Controller Item # LC135696

asked by: Timothy W

0

Expert Reply:

The wires for the Replacement Wiring Harness for Lippert Slide-Out Controller # LC135696 are 7-1/2" in length and the connector is 1-1/16" in length.

expert reply by: Kevin C

0

Answer 1

Unfortunately, I have no way to look up what parts are installed on your 2009 Heartland North Country. You may be able to contact the RV manufacturer with your VIN number to determine if they kept record of this when they manufactured the RV.…

view full answer...

Answer 2

Yes, you can absolutely replace a 13,500 btu air conditioner with a 15000 btu unit. The 15K btu units might weigh a few lbs more. They also will draw slightly more amperage. So they are undoubtedly interchangeable, as long as you can power it. For…

view full answer...

Answer 3

Sealant isn't required when installing the Rubber Wiper Seal and Bulb for RV Slide Out #SR68FR, but I would put a few screws in to help hold the seal since the trailer will bake in the sun and can cause issues with the 3M tape. At minimum I would…

view full answer...

Answer 4

The Tailgate Lift Support #ATL82GR will only work for the rear hatch of the 2007 Toyota Matrix. The back glass uses a different strut.

view full answer...

Answer 5

The correct liftgate support shock for a 2005 Chrysler Town and Country is the Liftgate Lift Support part #ATL64RR which will be a direct replacement for your existing. The installation is very easy as well, simply thread the old fittings out on each…

view full answer...

Answer 6

To find the correct slide out seal for your 2002 King of the Road Royalite 34RBW you will first need to identify what you have. Remove a portion of the seal to get the side profile of your current seal. Then, measure the length. While doing this you…

view full answer...

Answer 7

Manufacturers do not have a list available for the public to see exactly what motor was used on your 2006 Fleetwood Expedition so I would need to parts number listed on the motor to determine the correct replacement. I've attached a picture below…

view full answer...

Answer 8

The correct replacement for your Power Gear 522176/8730 is #LC383745.

view full answer...

Answer 9

Yes, you are correct! The Replacement Gear Motor Assembly for Lippert Component Power Gear Slide Out #LC67FR is the correct replacement for your 523143W motor.

view full answer...

Answer 10

The Replacement Gear Motor Assembly for Lippert Component Power Gear Slide Out part #LC67FR has a limited one year warranty as with all of their slide-out motors which will protect you from any manufacturing defects.

view full answer...

Answer 11

No, you would not be able to. I have spoken with Furrion about this exact question before because their written specifications are misleading. The 14,500 BTU Furrion Chill Replacement RV Air Conditioners, like the item #FR66SR you were looking at,…

view full answer...

Answer 12

We have several options for 17 inch extended struts but it comes down to what weight assist you would need. I attached a link to a page that has all of the options we carry but the #372-5200-30 has a 30 lb capacity.

view full answer...