Correct Replacement Shroud for a Dometic Brisk Air II

Question

Question:

Im looking for a a/c shroud that fits a dometic a/c model number 459516.701 Product number 991762356 Serial number 00221995 Thanks

asked by: Wesley R

1

Helpful Expert Reply:

I did some research and it appears that you have a Dometic Brisk Air II which would mean the Replacement RV Air Conditioner Cover for Dometic Brisk Air II # DMC46FR would be the correct replacement.

expert reply by: Bryce D

1

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

As long as the flat tow wiring is wired in before the 4-Way #C93ZV and you connect the power for the converter directly to the battery it will work. I have seen several use Magnetic Lights #TL21RK which they will wire in on the main harness to have…

view full answer...

Answer 3

When determine if you can fully open swing-out doors on your 2022 ProMaster 3500 with the Yakima EXO #Y34ZR, it really depends on how far your doors swing when in the open position. While the 90-degree swing has not been tested spcificially on a 2022…

view full answer...

Answer 4

Any type of hitch adapter or extender will have the unavoidable side-effect of causing a loss of about half of your hitch's rated capacity, both its tongue weight (TW) and it's gross towing weight (GTW). Hidden Hitch extender #HE18 and Curt…

view full answer...

Answer 5

In order to use a hitch-mounted bike rack like the Swagman Original #S64152-2 that you were looking at while towing a vehicle, you will just need to add the Roadmaster Dual Hitch Receiver Adapter #RM-077-4. This adapter will slide into the 2 inch…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue with them is comfortability when you…

view full answer...

Correct Replacement Shroud for a Dometic Brisk Air II

Product Page this Question was Asked From

Continue Researching