Is There a 2" Hitch Ball That Can Be Used on an Eaz-lift Elite Weight Distribution Hitch

Question

Question:

Do you offer a hitch with a 2” ball that would be compatible with the Eaz-lift Elite Weight Distributing Hitch Kit Eaz-lift part #48056? Thanks

asked by: Chad S

0

Expert Reply:

It sounds like you may just be needing a 2" hitch ball. We do not carry the Eaz-lift Elite Weight Distributing Hitch Kit Eaz-lift part number 48056. But from what I could find on it, it comes with a 2-5/16" hitch ball.

Most 2-5/16" hitch balls will use either a 1" or 1-1/4" shank diameter. You just need to determine the shank diameter you have for the 2-5/16" ball that comes on the Eaz-lift Elite Weight Distributing Hitch and get a 2" ball with the same shank diameter. You can then swap out your 2-5/16" ball with the 2" ball.

2" hitch ball with 1" shank diameter
- # C54CR

2" hitch ball with 1-1/4" shank diameter
- # A-90

expert reply by: Scott S

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

Hey Donald, the best Blue Ox weight distribution would be the pat #BXW0550 as it has a perfect tongue weight range for your 450 lb tongue weight trailer.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 12

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Is There a 2" Hitch Ball That Can Be Used on an Eaz-lift Elite Weight Distribution Hitch

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching