How to Measure for Replacement Awning Arms on a Lippert Edge Awning  

To order the correct Solera replacement arm size, simply measure the length of the wall-mount extrusion from top to bottom. I've pointed this out using the photo you sent in as an example. Short styles will measure 61-1/2" and use…

We did have the Black version as part LC62ED but that was unfortunately discontinued so you'll either need to use the White idler assembly with your current black drive assembly or you'll need to swap out both assemblies for a…

The Replacement Support Arm Assembly for Lippert Edge 58" Awning LC77VR has been discontinued, however we do have it's replacements the Replacement Drive Arm Assembly for Lippert Edge RV Awnings with LEDs #LC22ED and the Replacement…

For your 58 inch Lippert Edge RV awning the correct replacement idler arm is the part #LC62ED and the correct replacement drive arm (one with the motor) is the part #LC22ED.

I believe what you're looking for is the: -Replacement Pitch Arm Assembly for Solera XL 63" Flat Awning Support Arm #LC67VR. This arm measures 33" long, and is a direct replacement for the Solera XL 63" long flat awning support…

It sounds like you're referring to the pitch arm for your awning. If that's the case then you'll need to measure your support arm, the wall mount portion in particular. The Replacement Pitch Arm for Solera XL Flat RV Awnings part #LC67VR…

Since your Solera arm is 58 inches long that would indicate it's a Solera Edge awning which means for a replacement drive arm you would want the part #LC22ED or for a replacement idler arm part #LC62ED.

It sounds like you might be looking for the Replacement Retaining Washers for Solera Pitch Arm Assembly - Qty 1 #LC431583, which are used to replace the retaining washers needed for your Solera pitch arm assembly.

The correct arm assembly for your Lippert Edge is the Replacement Drive Arm Assembly for Lippert Edge RV Awnings with LEDs - White #LC22ED. I confirmed this with my contact at Lippert.

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…