Solution for a 2013 Subaru Outback Using a Thule Helium Bike Rack that Hits the Rear Bumper

Question

Question:

I have a Subaru Outback 2013, tried to put the rack on, but in the closed position the rack handles hit my bumper, so I cannot put the rack on in the upright position no bikes have you seen this before. Thought about trying a hitch extension,but diddNt know is if it would rattle too much

asked by: Colleen

0

Expert Reply:

For your 2013 Subaru Outback using the Thule Helium Platform XT Bike Rack for 2 Bikes # TH53GC you'll just need to use a hitch extender like the Hitch Extender For 2" Trailer Hitch Receiver 7" # HE06. This hitch extender will push out your rack an additional 7" so you'll be able to clear your bumper.

expert reply by: Bryce D

0

Answer 1

Any bike rack will require some degree of lifting to seat the bike within the carrier. A hitch mounted platform type rack is definitely the right choice when being concerned about lifting height; especially if you already have a hitch installed on…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack…

view full answer...

Answer 4

Hey Dave, so the best option for carrying your carbon frame bike and e-bike is the Swagman Escapee part #S39SR with the ramp #S59SR . It has the capacity for carrying an e-bike, is rated for travel trailer use, only touches the bikes by the tires…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

As long as the flat tow wiring is wired in before the 4-Way #C93ZV and you connect the power for the converter directly to the battery it will work. I have seen several use Magnetic Lights #TL21RK which they will wire in on the main harness to have…

view full answer...

Answer 7

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 8

When determine if you can fully open swing-out doors on your 2022 ProMaster 3500 with the Yakima EXO #Y34ZR, it really depends on how far your doors swing when in the open position. While the 90-degree swing has not been tested spcificially on a 2022…

view full answer...

Answer 9

Great question Gerard! The Thule Bike Adapter Bar #TH982XT could potentially pull the seat loose, but that would take either going over some pretty rough terrain for a prolonged time, or a whole lot traveling without checking on the bike. I will say,…

view full answer...

Answer 10

Hi Robert; hopefully your Roadmaster tow bar is one that attaches to direct-connect base plates as opposed to crossbar base plates; for example the 8,000 lb Roadmaster Sterling would be optimal. Assuming that, here is what you need to flat tow your…

view full answer...

Solution for a 2013 Subaru Outback Using a Thule Helium Bike Rack that Hits the Rear Bumper

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching