Confirming Connector For Installing T-One Vehicle Wiring Harness # 118540 on 2014 Ford Explorer
Question:
i recently bought a hitch and a wire harness for my 2014 ford explorer, Item # 118540, In the instructions it says to disconnect the connector on the passenger side and place this t connector in place. My ford only has one connector there and is not connected to anything. Ive been told its the correct harness but how do i install it, the connectors doesnt look like they match up.
asked by: Bradley N
Expert Reply:
Thank you for the image, I can confirm that is the correct connector for the T-One Vehicle Wiring Harness # 118540 on your 2014 Ford Explorer. You will place the cap back on the unused tee portion of the harness to protect the wiring.
(click to enlarge)
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How to Determine Correct Curt 4-Way Wiring Harness For 2024 Kia Telluride
- Q&A: How to Determine if 2014 Ford Explorer Has Factory Tow Package
- Q&A: Replacement Circuit Breaker for a Harbor Freight Badland ZXR 3,500 lb Winch
- Q&A: Needing to Install a Brake Controller 2017 Ford Explorer with Ford Factory Class 3 Tow Package
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Replacement Hub and Spindle for 2014 Ranger Trailer
- Q&A: What is Standard Trailer Wheel Bolt Pattern for 14 inch Wheels
- Article: Trailer Wiring Diagrams
- Article: Performance Chips and Modules
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure a Trailer Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern