Replacement Hardware for Westin HDX Grille Guard on 2013 Chevy Silverado 1500

Question

Question:

Is this the part # for replacement brackets and hardware for a Westin HDX grille guard?

asked by: Alexa

0

Expert Reply:

The # 57-229PK is for a Westin HDX Grille Guard that fits the GMC Sierra 1500. Since you have a 2013 Silverado 1500 you need the # 57-227PK which will allow you to mount the # 57-2275 or # 57-2270.

expert reply by: Robin H

0

Answer 1

The mounting brackets you need are part #57-229PK. They're specifically for the Westin HDX grille guard, part #57-2295 on your 2010 GMC Sierra 1500.

view full answer...

Answer 2

I found a solution for you. However, the product that you listed #57-250PK is not confirmed to fit a HDX Grille Guard on a 2011 GMC Sierra 1500. The Mounting Bracket Parts Kit #57-229PK is the confirmed kit needed to install the Westin HDX model…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 7

Since the Truxedo Lo Pro you'd have installed on your 2013 Chevy Silverado 3500HD long bed would be the part #TX571601 the correct replacement tarp would be the part #TX5716-CVR.

view full answer...

Answer 8

The Air Lift Wireless AIR Compressor System #AL74000 will show an error whenever there is any type of issue with the system. Generally this is an issue with the remote communicating with the system, a blockage, or a leak. I would inspect the…

view full answer...

Answer 9

You are a little on the warm side for your transmission fluid. If you can keep it under 200 degrees you will have the max life out of it. That being said transmissions really start to go downhill at 260 degrees. The Derale cooler part #D13503 with…

view full answer...

Answer 10

Normally, the tongue weight should be somewhere between 10 and 15 percent of the loaded trailer weight. For your trailer it would mean somewhere between 780 and 1200-lbs. The #C17501 system is designed for tongue weight between 1,000 and 1,500-lbs so…

view full answer...

Answer 11

Congrats on the new trailer! However you need to know the loaded tongue weight of your trailer, as the dry weight is not a useful figure. With your trailer fully loaded like you'll be towing it use either the scale method in the below help…

view full answer...