How to Install RV Awning Locking Pins on Awning That Does Not Use Lock Pins

Question

Question:

Where and how to install these locking pins? Will these fit a 2016 Dutchman Kodiak. It is a carefree awning Thank you

asked by: Paul

0

Expert Reply:

It sounds like your awning might not utilize locking pins and in which case you'd need to do some modifications to install the RV Awning Locking Pins part # 3721164. I have attached the steps for this below.

expert reply by: Conner L

0

How to Install RV Awning Locking Pins on Awning That Does Not Use Lock Pins
(click to enlarge)

Answer 1

There is actually an electric brake kit available for RoadMaster tow dollies with part numbers that start with 2000 or 444. It is part #RM-2000-6. You can use this kit to either replace damaged brakes on your newer RoadMaster Tow Dolly or add them…

view full answer...

Answer 2

There is actually an electric brake kit available for RoadMaster tow dollies with part numbers that start with 2000 or 444. It is part #RM-2000-6. You can use this kit to either replace damaged brakes on your newer RoadMaster Tow Dolly or add them…

view full answer...

Answer 3

When the view is stuck what is the lighting functions of the setup doing? Are any of the turn signals or brake lights sticking on at the same time or are they functioning fine? If the light functions are staying on you have a lighting short that is…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

I would be happy to. To flat tow your 2017 Ford F-250 you will need the following parts: Tow Bar and Safety Chains - etrailer XHD Non-Binding Tow Bar item #e84ZR Base Plate Kit - Roadmaster Direct-Connect Base Plate Kit - Removable Arms item…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

There are a couple of options that'll work great with your Lippert Turning Point Pin Box, however one hitch stands out to me more than others. Take a look at the: -Curt E16 5th Wheel Trailer Hitch - Slide Bar Jaw - 16,000 lbs #C16115 This 5th…

view full answer...

How to Install RV Awning Locking Pins on Awning That Does Not Use Lock Pins

Product Page this Question was Asked From

Continue Researching