Rear Anti-Sway Bar For 2013 Ram 3500 4WD Without Factory Swaybar

Question

Question:

I hae a 2013 Ram 3500, Swd, gasser 4wd drive that did not come with a factory rear swaybar. Will this work or do I need something else? RM94GR

asked by: Tammy

0

Expert Reply:

We do have a rear anti-sway bar that will work for your 4WD 2013 Ram 3500, but since you do not have the factory rear sway bar you'll actually need a different part than the one you mentioned. The correct fit for your truck is the following:

- Roadmaster Rear Anti-Sway Bar # RM-1129-124

Just keep in mind this does not work with a gooseneck hitch installed (there wouldn't be an anti-sway bar option if you have a gooseneck).

expert reply by: Kyle S

0

Answer 1

The rear anti-sway bar that fits the 2016 Ram 3500 is #RM-1129-124. Another option that will help with stability is TorkLift StableLoad Rear Suspension Upgrade with Quick-Disconnects - Lower Overload Springs Item #TLA7310. As long as your truck has…

view full answer...

Answer 2

Yes, the Roadmaster Rear Anti-Sway Bar #RM-1129-124 will fit just fine with a TorkLift SuperHitch like part #TLD1108 on your 2014 Ram 3500. The reason we have the notes about fitment with 5th wheel and gooseneck hitches for the sway bar is because…

view full answer...

Answer 3

The Roadmaster Rear Anti-Sway Bar #RM-1129-124 is going to install away from the air bags so you shouldn't have any issues have both installed on your 2006 Dodge Ram 2500. I actually found a customer submitted photo showing the two side-by-side…

view full answer...

Answer 4

The Roadmaster rear sway bar part #RM-1129-124 that you referenced is a confirmed fit for your 2016 Ram 3500 and will greatly reduce the sway of the setup that's caused by the weight of the camper you have installed in the bed of the truck.

view full answer...

Answer 5

Roadmasters priority when it comes to their sway bars is top notch quality and the easiest install for the customer. This typically cuts the install time down enough that you end up saving money if you pay to have the bars installed or decide to do…

view full answer...

Answer 6

Roadmaster's fitguide lists that the Roadmaster Rear Anti-Sway Bar #RM73FR will fit your 2019 Ram 3500 4WD with factory air suspension.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Scott, so we do have the SumoSpring Solo kit part #SSR-130-54 that is a confirmed fit for your 2018 Ford motorhome built on an E-450 chassis.

view full answer...

Answer 12

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Rear Anti-Sway Bar For 2013 Ram 3500 4WD Without Factory Swaybar

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching