Will Fan-Tastic RV Roof Vent Replace Vent of Heartland RV Cyclone

Question

Question:

I have a powered lift fan in my RV already. There is a wall switch that when turned on opens the powered lift. The unit has a dead man switch built in. When the lid is opened enough to ground the switch the fan will turn on. The unit has a built in rain sensor as well. Can you tell me if this unit you sell would be a replacement to my build in unit already? My units dead man switch is broken and doesnt always engage to turn the fan on and sometimes holds the lid open slightly

asked by: Jeremy V

0

Expert Reply:

The Fan-Tastic RV roof vent part # FV803350 that you referenced is designed to fit the standard RV roof vent opening of right at 14 inches so it would easily fit in place of the vent you have now. Essentially all of the RV roof vents are designed to fit the same opening dimensions.

expert reply by: Jameson C

0

Answer 1

You should be just fine replacing your two roof vents with the Fan-Tastic Vent Roof Vent #FV803350 since these fit the standard 14-1/4 x 14-1/4-inch RV roof opening size. Since you are replacing two 12V powered vents with two similar units your…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Although I would not be able to speak on the installation of the part(s) you received for your trailer, I can tell you that the TremPro 644 Silicone Sealant part #0160297 will do an excellent job of sealing your new aluminum panel to the trailer and…

view full answer...

Answer 5

Hey Bruce, for a replacement Fan-Tastic brand RV roof vent I really like the part #FV803350 as it has a variable speed, reversible fan, a built in thermostat, power lid lift, and a rain sensor to auto close it in case it starts raining. The only…

view full answer...

Answer 6

I am afraid we are not able to tell specifically what model of FanTastic vent you have based on your pictures. It certainly appears to be an older model. If you are looking to replace individual parts of your fan we will need to know the exact model.…

view full answer...

Answer 7

Thank you so much for the info and the pictures! According to my research it looks like your Cummins Onan RV Generator uses a 3/8" NPT Female fitting so you'll need a hose like part #100040-144-MBS. I have attached a link to all of our hose…

view full answer...

Answer 8

Fan-Tastic vents do not have replacement circuit boards for their RV roof vents, and the FV6300 is no longer available, so the best we can offer is a new roof vent since yours is acting up. I recommend going with an option that does have available…

view full answer...

Answer 9

The model number B2000RBT that you mentioned is the motor model number for the Fan-Tastic Roof Vent. If the fan only runs for a few minutes it sounds more likely that the fan motor is going out. First, it is a good idea to make sure you are getting…

view full answer...

Answer 10

Lippert no longer offers the individual steps as a replacement part, but the motor is available as part #LC301695 and the control module is part #LC301702, If the step in question was bent, it might be possible to straighten it, as the steps, slide…

view full answer...

Answer 11

Sounds like you are looking for a replacement fan blade and motor setup for a Fan-Tastic roof vent part number 5300. For that you'd want the part #FVK8017-00 and you'd be set.

view full answer...

Will Fan-Tastic RV Roof Vent Replace Vent of Heartland RV Cyclone

Product Page this Question was Asked From

Continue Researching