Replacement Mounting Hardware Kit that Fits Thule Mountaineer

Question

Question:

I have a 2003 Thule mountaineer cargo carrier that I need new mounting brackets and carriage bolts as mine are all rusted, can u help me find the replacement parts?

asked by: Ed

0

Expert Reply:

The Thule hardware # TH04997 kit is a confirmed fit for your Thule Mountaineer roof cargo box.

expert reply by: Jameson C

0

Answer 1

From my research I found the box mounting dimensions for the 669ES Mountaineer ES require 23 5/8" of minimum crossbar spacing, 34" of maximum crossbar spacing, 20" mounting width and 26" of rear hatch clearance. If this is not the…

view full answer...

Answer 2

It sounds like you are looking for replacement mounting hardware for your Thule Mountaineer Cargo Box. For this you will just need the Replacement QM3 - Quick Mount Hardware #TH04997. This kit consists of the complete mounting hardware set, including…

view full answer...

Answer 3

For older Mountaineer boxes, the correct replacement hardware is #TH04997. I recommend sticking with the correct replacement hardware because to use a different style, you would have to make modifications to the box and that can compromise the…

view full answer...

Answer 4

The bolts that come with the QM3 kit part #TH04997 are M6 which we offer as a replacement part with #TH10403. We also have the wing nuts by themselves too with part #TH04877.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 12

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Replacement Mounting Hardware Kit that Fits Thule Mountaineer

Product Page this Question was Asked From

Continue Researching