Can You Replace Valve on Taylor Made Tuff End Round Boat Fender for Commercial Boats - 21" Diameter

Question

Question:

I have a Taylor Made Tuff End Round Boat Fender and I am looking to purchase the Trivalve for it. Do you sell just the trivalve.

asked by: Frank

0

Expert Reply:

The Taylor Made Tuff End Round Boat Fender for Commercial Boats part # 36961152 we do not offer a replacement valve for. If you need this as yours is lost or damaged, your best option is to reach out to the manufacturer directly. The only option we'd have is a new unit. I have attached a full selection of our inflatable bumpers for you below as well.

expert reply by: Conner L

0

Answer 1

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 2

You currently have 2 options since your current Airborne Sidewinder pin box is not going to fit your new 2022 Vengeance Rogue toy hauler. We do have the new Sidewinder #RP34FR which has added the new bolt pattern for the Lippert Rhino pin box.…

view full answer...

Answer 3

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 4

The SuperSprings #SSA22 would be a smart choice to raise your 2012 Ford F-250 when pulling your fifth wheel. They are designed to prevent the sagging you are experiencing and should put you pretty close to level. If you take a look at the attached…

view full answer...

Answer 5

If your Pullrite is the ISR (Industry Standard Rail) model, it would indeed be compatible with the #BWRVK2402 B&W fifth wheel rail/bracket kit. You can confirm this for yourself by measuring the front to back distance, center to center of the…

view full answer...

Answer 6

To know if your 2017 Ford F-350 has an in-bed puck system installed you'll just need to look and see if you have four rounded attachment points (usually covered up when not in use, like in the attached picture). If you don't see these in your…

view full answer...

Answer 7

Yes, the Taylor Made Tuff End Round Boat Fender for Commercial Boats #36961152 ships deflated. To inflate the boat fender you will just need a hand compressor or hand pump. The Taylor Made Tuff End Round Boat Fender for Commercial Boats #36961152 has…

view full answer...

Answer 8

I looked at the owner's manual for your 2014 Chevrolet Silverado 1500, and for the 4WD Crew Cab, Standard Box with a 5.3L Engine and a 3.42 axle ratio, the maximum trailer weight for the vehicle to tow is 9,500 pounds. The GCWR (Gross Combined…

view full answer...

Answer 9

I checked with the manufacturer and you will want to use 1 inch long #8 oval head stainless steel mounting screws to mount the LED Boat Navigation Light item #TN52ZR.

view full answer...

Answer 10

To wire up your 2020 Jeep Wrangler so that it accepts the signal lights from your RV I highly recommend the Roadmaster Diode Flexo-Coil Wiring Kit #RM-15267. This will tap into the tail light circuits of the Jeep and provide you with a 6-Way to mount…

view full answer...

Can You Replace Valve on Taylor Made Tuff End Round Boat Fender for Commercial Boats - 21" Diameter

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching