MaxxFan Deluxe Fan Wont Reverse

Question

Question:

Hi. My MaxxAir Deluxe suddenly stopped operating in the counter-clockwise direction i.e. air exhaust, but still works in the clockwise direction i.e., air intake. Is this likely a problem with the motor or some other part? Thanks

asked by: Heidi T

0

Expert Reply:

If your MaxxFan Deluxe fan won't reverse, it won't be the motor as that is simply power, it is likely the circuit board. If you have a MaxxFan Deluxe 00-07000K, 00-07500K, 00-08500K, 00-08700K, or 00-08900K you can replace the circuit board with the Replacement Printed Circuit Board for MaxxAir Powered Lift RV Roof Vents w/ Reversible Fan # MA10A21275K.

expert reply by: Kyle S

0

Answer 1

The circuit board of your MaxxFan might need to be reset. If you can cut power to the fan by pulling a fuse I'd try that first. If that does not work then there would be an issue with the circuit board and you'd want to replace it with the…

view full answer...

Answer 2

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...