What Is The Maximum Height Achievable For the CargoSmart Folding Workbench Brackets # 3481744?

Question

Question:

Part Number 3481744: The description reads 26inch - 40inch tall. How is that measured? To the E track? To the top of the shelf? Please specify in relation to the center height of E-track from the ground. Thanks

asked by: Mike C

1

Helpful Expert Reply:

I grabbed one of the CargoSmart Folding Workbench Brackets # 3481744 and got the following measurement for you. With the upright in the tallest position and the threaded insert pushed all the way in, I got a measurement of 40" from the ground to the top of the bracket for mounting your top. With the insert unthreaded as far as it could go while still having enough threads on the foot to not damage the threads it is 42-3/4" to the top of the bracket. The E-track insert will be about a 1/4"higher than this to the bottom of the groove or top of the slot on your E-track. So for a maximum height you are looking at 43" to the top of the E-Track channel from the floor surface.

expert reply by: Bud M

1

Answer 1

The CargoSmart Folding Workbench #3481744 will sit approximately 3-3/4 to 4" out from the CargoSmart X-track mount #3481770. The braces on the CargoSmart Folding Workbench are 2-1/2" tall and the bracket that mounts in the X track is sits…

view full answer...

Answer 2

On an 4 foot long section of E-track #EM19147 and 2 screws every 16 inches that is a total of 6 screws in the aluminum frame. This most likely will not get you near the capacity of the E-track. I recommend bolting through the aluminum frame so that…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Waylon, it does look like the Dexstar Steel Mini Mod Trailer Wheel #AM20539 is the same thing as the Dexstar 17-233 wheels you're referring too. These are silver wheels with a 6 on 5 1/2 bolt pattern, a 0 offset, and are made in the USA.

view full answer...

Answer 6

The legs for the CargoSmart Folding Workbench Brackets #3481744 will sit 22-21/2" away from the wall when in the deployed position, and then the brackets are 2-1/2" tall so they will stick out that far from the wall. My contact at…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

What Is The Maximum Height Achievable For the CargoSmart Folding Workbench Brackets # 3481744?

Product Page this Question was Asked From

Continue Researching