Dimensions of Stromberg Carlson 100 Series 5th Wheel Tailgate for 2016 Toyota Tundra

Question

Question:

Toyota 100 Series by Stromberg dimensions

asked by: Lynn W

0

Expert Reply:

The Stromberg Carlson 100 Series 5th Wheel Tailgate # VGT-70-100 is the correct model for your 2016 Toyota Tundra. This measures 63-3/4" left to right at the top and 64" across at the bottom. The height on the side is 25-1/4" and it is approximately 14" tall in the middle.

expert reply by: Robin H

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 6

You're correct. The repalcement for your existing B12EA-22 brake would be #AKEBRK-7R-SA for the right side and #AKEBRK-7L-SA for the left.

view full answer...

Answer 7

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 8

Hey Tim, thanks for the picture of your current brake assemblies. While what you have doesn't look exactly like a free-backing setup you definitely can replace what you have with them. For that I would go with the etrailer part #AKFBBRK-35 which…

view full answer...

Answer 9

Hi Larry, So we have a couple bumpers that may work, though each is 96 inches long. They can be cut to length though, and the difference is their width, as one is 3" wide and the other 4" wide to fit different size bumpers: - Pre-Drilled…

view full answer...

Answer 10

I do have an option for you but the Stromberg Carlson 4000 Series 5th Wheel Louvered Tailgate part #VGD-10-4000 does not have a spot for the factory backup camera. Therefore you would either need to find a way to mount this yourself, go without, or…

view full answer...

Answer 11

Based on the information you provided either the Titan Hydraulic Brake Kit - Free Backing - 10" - Left and Right Hand Assemblies - 3,750 lbs #T4071600-500 or #T4423500-400 will fit your drums. The only difference between these two brakes is the…

view full answer...

Answer 12

I checked with Erickson and their Removable Motorcycle Wheel Chock item #EM07506 does not have a weight rating. It is made of steel and works with bikes that have up to 6" tires. So long as your Honda and Kawasaki do not have wider tires this…

view full answer...

Dimensions of Stromberg Carlson 100 Series 5th Wheel Tailgate for 2016 Toyota Tundra

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching