Hitch and Coupler Lock Set Which Fits On a 2019 Airstream International 23 Travel Trailer

Question

Question:

Will this set of locks work on the Demco coupler on my 2019 Airstream International 23?

asked by: Mike H

0

Expert Reply:

For your 2019 Airstream International 23 having a rolled lip on the coupler you will want to use the Master Lock Trailer Hitch Receiver Lock and Coupler Lock Set # 3794DAT. The etrailer Hitch and Coupler Lock Set # e68ZR you found is designed to fit on a flat lip coupler.

expert reply by: Bud M

0

Answer 1

When it comes to a hitch and coupler lock Set for a Demco hitch on your 2022 Airstream 25 foot Globetrotter The etrailer Hitch and Coupler Lock Set - 2 inch Hitch - 2-5/16 inch Ball #e68ZR will work unless you have a double-walled hitch or a factory…

view full answer...

Answer 2

I like the etrailer Trailer Coupler Lock, #e98895. This is lower price point but still very good quality lock for flat lip 2-5/16" ball couplers. This is made of aluminum construction with a shuttered keyhole that keeps out dirt and debris to…

view full answer...

Answer 3

I have a solution for you but the etrailer Hitch and Coupler Lock Set - 2" Hitch - 2-5/16" Ball item #e68ZR slides onto a standard coupler and most likely won't work on yours if it has a wider coupler and a larger rolled lip than in the…

view full answer...

Answer 4

Yes, the etrailer Trailer Coupler Lock for Flat Lip 2-5/16" Ball Coupler #e98895 will work on your coupler lip that is 3-3/4 inches wide.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...